ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)Pliers

(2)7/16" Open End or Box Wrenches

(2)9/16" Open End or Box Wrenches

REMOVAL OF PARTS FROM CARTON

Refer to carton contents on page 2 and to the hardware chart on page 3 to lay out and identify parts and hardware needed to assemble the spreader.

ASSEMBLY OF SPREADER

1.Place the spreader upside down.

2.Assemble the long spacer tube and a 3/4" washer onto the end of axle of the axle that has the small drilled hole (right hand side). See figure 1.

3.Place the idler wheel (no notch in hub) onto the axle. The air valve should face to the outside. See figure 1.

4.Assemble one or two more 3/4" washers onto the axle and then assemble the 1/8" x 1-1/2" cotter pin.

5.Place the short spacer tube and a 3/4" washer onto the end of the axle that has the large drilled hole (left hand side). See figure 2.

6.Place the drive wheel onto the axle. The notched hub and the air valve should face to the outside. See figure 2.

7.Fasten the wheel to the axle using a 1/4" x 1-3/4" hex bolt and a 1/4" hex lock nut. See figure 2.

 

SHORT

 

SHAFT

SPACER

 

SUPPORT

TUBE

1/4" x 1-3/4"

PLATE

 

 

HEX BOLT

 

 

1/4" HEX

 

LOCK NUT

DRIVE

3/4" WASHER

WHEEL

FIGURE 2

SMALL

HOLE

IDLER

WHEEL

SHAFT

SUPPORT

PLATE

LONG

SPACER

TUBE

3/4" WASHERS

1/8" x 1-1/2"

COTTER PIN

8.Tip the spreader over to rest on the front edge of the hopper and on the wheels.

9.Remove the middle 3/8" hex bolt, flat washer and hex lock nut that fasten the shaft support plate to the crossover tube. Do not loosen or remove the two outer bolts. See figure 3.

CROSSOVER

TUBE

SHAFT

SUPPORT

PLATE

REMOVE

MIDDLE 3/8"

FIGURE 1

BOLT, WASHER AND NUT

FIGURE 3

4