18.Assemble the flow control arm to the flow control mount- ing bracket using one 1/4" x 5/8" hex bolt and one 1/4" hex lock nut. Do not over tighten. The flow control arm must pivot freely. See figure 7.
19.Hook one end of the spring through the hole at the bend in the flow control rod. Hook the other end in the hole in the flow control mounting bracket. See figure 7.
FLOW CONTROL ARM
FLOW CONTROL
MOUNTING BRACKET
21.Hook the free end of the flow control rod through the hole in the slide gate bracket located near the bottom of the hopper. See figure 9.
SLIDE
GATE
HOPPERBRACKET
FLOW
CONTROL
ROD
EXTENSION
SPRING
1/4" HEX LOCK NUT
FIGURE 7
1/4" x 5/8"
HEX BOLT
FLOW
CONTROL
ROD
FIGURE 9
22. Assemble the flow control mounting bracket and the |
short handle tube to the long handle tube using two 1/4" |
x |
hex lock nuts. See figure 10. Do not tighten yet. |
23. Place a handle grip on each handle tube. See figure 10. |
20.Place a 5/16" flat washer over the end of flow control rod and insert the rod through the slot in the flow control mount bracket and through the hole in the flow control link. Secure with a 3/32" x 3/4" cotter pin. See figure 8.
FLOW
CONTROL
ROD
EXTENSION | FLOW |
SPRING | |
| CONTROL |
| LINK |
5/16" FLAT
WASHER
FLOW CONTROL | 3/32" x 3/4" | |
COTTER | ||
MOUNTING BRACKET | ||
PIN | ||
|
FIGURE 8
1/4" x | FLOW CONTROL | |
MOUNTING BRACKET | ||
HEX BOLTS | ||
|
| 5/16" |
|
| 5/16" |
|
| FLAT |
|
| FLAT |
|
WASHERS |
| |
WASHERS | 1/4" HEX | |
|
| |
HANDLE |
| LOCK NUTS |
|
| |
TUBE | HANDLE |
|
(SHORT) | TUBE |
|
| (LONG) | HANDLE GRIP |
FIGURE 10
6