IMPORTANT: Do Not asssemble handle tube to same
side of crossover tube as shaft support plate.
9.Place the long handle tube onto the crossover tube on the side opposite from the shaft support plate. Fasten with the bolt, washer and nut removed in the previous step. See figures 4 and 5. Do not tighten at this time.
10.Assemble two handle braces to the inside of the hopper
frame, one on each side, using two 1/4" x
11.Assemble the other end of the two handle braces to the long handle tube using a 1/4" x
5.
12.Tighten all nuts and bolts in same sequence as assembled in steps 9 through 11. See figure 5.
HANDLE TUBE (LONG)
HEX BOLT 1/4" x
HITCH
BRACE HEX BOLT 1/4" x
MIDDLE
NUT 1/4"
NYLOCK NUT
CROSSOVER
MIDDLE TUBE
BOLT
SHAFT
SUPPORT
PLATE
FIGURE 5
5
13.Assemble the leg stand tube to the handle tube (long) using two 1/4" x
14.Place a vinyl cap over the end of the leg stand tube.
See figure 6.
HANDLE TUBE (LONG)
1/4" x
HEX BOLTS
1/4"
NYLOCK NUTS
VINYL CAP | LEG STAND TUBE |
FIGURE 6
15.Assemble the flow control link (end with small hole) to the flow control arm using a 1/4" x 1" hex bolt, a nylon washer and a 1/4" nylock nut as shown in figure 7. Tighten carefully. The flow control link should not be loose but should pivot with no more than slight resistance.
FLOW CONTROL |
|
LINK | FLOW |
| CONTROL |
| ARM |
1/4" x 1" |
|
HEX BOLT |
|
| 1/4" |
| NYLOCK |
| NUT |
SMALLEST
HOLE
NYLON
WASHER
FIGURE 7