16.Assemble the flow control arm to the flow control mounting bracket using a 1/4" x 1" hex bolt, two nylon washers and a 1/4" nylock nut as shown in figure 8. Tighten carefully. The flow control arm should be snug, but should pivot with no more than a slight resistance.

17.Assemble the vinyl grip. See figure 8.

VINYL GRIP

FLOW

FLOW CONTROL

MOUNTING

CONTROL

BRACKET

ARM

 

1/4" x 1"

HEX BOLT

 

1/4"

 

NYLOCK

(2) NYLON

NUT

 

WASHERS

 

FIGURE 8

19.Hook the free end of the flow control rod through the hole in the slide gate bracket located near the bottom of the hopper. See figure 10.

SLIDE

GATE

HOPPER BRACKET

FLOW

CONTROL

ROD

FIGURE 10

20.Assemble both the flow control mounting bracket and the short handle tube to the long handle tube. Use two

1/4" x 1-3/4" hex bolts, four 5/16" flat washers and two 1/4" nylock nuts as shown in figure 11. Do not tighten at this time.

21.Place a handle grip on each handle. See figure 11.

18.Place a 5/16" flat washer onto the end of the flow control rod. Insert the end of the flow control rod through the slot in the flow control mounting bracket and through the hole in the flow control link. Secure with a 3/32" x 3/4" cotter pin. See figure 9.

3/32"

COTTER

HANDLE GRIP

1/4" x 1-3/4"

HEX BOLT

FLOW CONTROL MOUNTING BRACKET

5/16" FLAT WASHER

FLOW

CONTROL

ROD

PIN

HANDLE TUBE (SHORT)

HANDLE TUBE (LONG)

1/4"

NYLOCK

5/16" NUT FLAT

SLOT

FLOW

CONTROL

LINK

FIGURE 9

6

WASHERS

FIGURE 11