ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)Pliers

(1)Hammer

(2)7/16" Open or Boxed End Wrenches

1.Remove the spreader, the loose parts and the hardware package from the carton. Lay out parts and hardware and identify using the illustrations on pages 2 and 3.

2.With the spreader resting upside down on the top of the hopper, assemble a spacer and then a 1/2" flat washer onto each end of the axle. See figure 1.

AXLE

SPACER

1/2" FLAT WASHER

FIGURE 1

3.Place a wheel onto the end of the axle that has no cross hole.The long end of the hub goes to the inside.

See figure 2.

4.Place a 1/2" flat washer onto the axle and then lightly tap a hub cap onto the axle until it is snug against the washer and wheel hub. See figure 2.

NO CROSS HOLE

WHEEL

1/2" FLAT

WASHER

HUB CAP

FIGURE 2

5.Place the drive wheel onto the end of the axle that has an indent. The long end of the hub goes to the inside.

See figure 3.

6.Lightly tap a hub cap onto the axle until it is snug against the wheel. See figure 3.

HUB CAP

WHEEL

FIGURE 3

7.Remove the middle 1/4" hex bolt, flat washer and hex lock nut from the crossover tube. See figure 4.

CROSSOVER

TUBE

MIDDLE NUT

SHAFT SUPPORT

MIDDLE BOLT PLATE & WASHER

FIGURE 4

4