IMPORTANT: Do Not asssemble handle tube to same side of crossover tube as shaft support plate.

8.Place the long handle tube onto the crossover tube on the side opposite from the shaft support plate.

Fasten with the bolt, flat washer and nut removed in the previous step. See figures 4 and 5. Do not tighten at this time.

9.Assemble two handle braces to the inside of the hopper frame, one on each side, using two 1/4" x 1-1/2" hex bolts and two 1/4" nylock nuts. See figure 5. Do not tighten at this time.

10.Assemble the other end of the two handle braces to the long handle tube using a 1/4" x 1-1/2" hex bolt and 1/4" nylock nut. Do not tighten at this time. See figure 5.

11.Tighten all hex lock nuts and bolts in same sequence as assembled in steps 9 through 11. See figure 5.

HANDLE TUBE (LONG)

HEX BOLT 1/4" x 1-1/2"

HITCH

BRACE HEX BOLT 1/4" x 1-1/2"

MIDDLE

NUT

1/4"

NYLOCK NUT

CROSSOVER

12.Assemble the leg stand tube to the handle tube (long) using two 1/4" x 1-1/2" hex bolts. Secure tightly with two 1/4" nylock nuts. See figure 6.

13.Place a vinyl cap over the end of the leg stand tube.

See figure 6.

HANDLE TUBE (LONG)

1/4" x 1-1/2"

HEX BOLTS

1/4"

NYLOCK NUT

VINYL CAP

LEG STAND TUBE

FIGURE 6

14.Assemble the flow control link (end with small hole) to the flow control arm using a 1/4" x 1" hex bolt, a nylon washer and a 1/4" nylock nut as shown in figure 7. Tighten carefully. The flow control link should not be loose but should pivot with no more than slight resistance.

FLOW CONTROL

MIDDLE TUBE BOLT &

LINK

FLOW

WASHER

SHAFT

SUPPORT

PLATE

FIGURE 5

CONTROL

ARM

1/4" x 1"

HEX BOLT

1/4" NYLOCK NUT

SMALLEST

HOLE

NYLON

WASHER

FIGURE 7

5