ENGLISH

RULES FOR SAFE OPERATION

Preventing accidents is the responsibility of every equipment operator. The following general safety precautions must be fully understood and followed by every operator.

1.Do not at any time carry passengers in this cart. It is designed for carrying materials only and not intended to carry passengers

2.Be careful on any grade (hill) and stay off of steep grades.

3.Use caution when loading cart to avoid tipping.

4.Avoid large holes and ditches when transporting loads.

Your Lawn Cart carton contains a hardware package with parts as shown in the chart below and in fi gure 1.

Contents of Hardware Pack: (See figure 1)

REF.

QTY.

DESCRIPTION

94 Carriage Bolt

104 Hex Bolt

114 Large Flat Washer

128 Hex Nut

134 Flat Washer

148 Lock Washer

154 Cotter Pin

HARDWARE REFERENCE CHART

9

10

15

12

13

14

11

 

 

 

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED

(2) 14 MM Wrenches or Adjustable Wrenches

(1) Pliers

NOTE: Do not tighten nuts until entire lawn cart has been assembled.

1.Refer to parts drawing on page 3 for assembly and reference numbers.

2.Turn the tray (Ref. 1) upside down and support at each end with two boxes or two saw horses.

3.Slide the handle extension (Ref. 5) into ends of upper handle (ref. 4) and align holes.

4.Position handle assembly on tray as shown in parts drawing. Insert one carriage bolt (Ref. 9) through one of the holes at the rear of the tray and on through the handle assembly.

5.Hold a channel leg (Ref. 6) so that the two holes for the leg brace are toward the rear of the tray. Loosely secure the channel leg (Ref. 6) to the carriage bolt installed in step 4 using one fl at washer (Ref. 13), lock washer (Ref.

14)and hex nut (Ref. 12).

6.Repeat step 5 for the other channel leg.

7.Place one U-clamp (Ref. 8) at the end of one handle extension and align holes. Insert a carriage bolt (Ref. 9) through a hole at the front of the tray and through the U-clamp, the handle extension and the front hole in the channel leg. Secure loosely with one fl at washer (Ref. 13), lock washer (Ref. 14) and hex nut (Ref. 12).

8.Repeat step 7 for the other side of tray.

9.Slide axle (Ref. 3) through both U-clamps and center axle left to right.

10.Place one large fl at washer (Ref. 11), a wheel (Ref. 2) and another large fl at washer (Ref. 11) onto one end of axle.Assemble two cotter pins (Ref.15) to axle, securing wheel and washers between them.

11.Repeat step 10 for other end of axle.

12.Attach leg brace (Ref. 7), as shown, to channel legs with four hex bolts (Ref. 10), lock washers (14) and hex nuts (12).

FIGURE 1

13. Tighten all nuts securely using wrenches.

 

2