7.At this time tighten all bolts starting with the bolts in figure 2, then the bolts in figure 3.

8.Install the drain in the rear of the tank as shown in figure 4. Place a 3/4" garden hose gasket onto the drain body and insert the drain body out through the hole in rear of the tank. Outside the tank, assemble the nylon washer, then the nylon nut onto the drain body. Tighten the nut securely enough to prevent leaking, being careful not to damage the plastic parts. Place the O-ring inside the nylon cap and screw the cap onto the end of the drain body. See figure 4.

NYLON

WASHER

NYLON NUT

O-RING

NYLON CAP

HOSE

GASKET

DRAIN BODY

FIGURE 4

9.Assemble the boom mount bracket to the rear of the hitch tubes using two 5/16" x 2" hex bolts and 5/16" hex nuts. See figure 5.

BOOM MOUNT

BRACKET

5/16" HEX NUT

5/16" x 2"

HEX BOLT

FIGURE 5

10.Assemble the boom bars to the boom mount bracket using two 5/16" x 1-1/4" carriage bolts, tooth lock washers (between the bar and bracket), 5/16" flat washers and knobs. The boom connecting hose should extend upward. See figure 6.

NOTE: Make sure the nozzle openings face straight down when the boom bars are in the horizontal operating position.

 

BOOM CONNECTING HOSE

 

5/16" WASHER

 

WASHER

KNOB

(TOOTH LOCK)

 

BOOM BAR

CARRIAGE BOLT 5/16" x 1-1/4"

FIGURE 6

11.Assemble the large and small spray gun clips to the side of the tank using two #10 x 1/2" screws and #10 lock washers. See figure 7.

#10 x 1/2"

 

SCREW

 

 

SPRAY GUN

#10 LOCK

CLIP (LARGE)

WASHER

SPRAY GUN

CLIP (SMALL)

 

FIGURE 7

VIEWED FROM REAR

5