12.Insert a garden hose gasket into the swivel nut on the bypass/return hose. Screw the nut onto the upper outlet of the "Y" valve fitting. Place the other end of the hose down through the hole at the rear of the tank. See figure 8.
13.Insert a garden hose gasket into the swivel nut on the boom connecting hose. Screw the nut onto the lower outlet of the "Y" valve fitting. See figure 8.
14.Slide the 1/4" hose clamp onto the spray gun hose. Push the hose onto the hose adapter on the side of the "T" fitting as shown in figure 8. Tighten the clamp around the hose and the adapter. Wrap the hose around the tank and snap the spray gun into the clips on the side of the tank.
15.Carefully screw the pressure gauge into the top of the "T" fitting. See figure 8.
BYPASS/RETURN HOSE
SPRAY
GUN | 1/4" HOSE | |
HOSE | ||
CLAMP | ||
|
GARDEN
HOSE
GASKET
PRESSURE
GAUGE
BOOM CONNECTING HOSE
FIGURE 8
16.Attach the sprayer to the tractor hitch and connect the wiring to the tractor battery. The red wire must be connected to the positive post on the battery or to the "HOT" connection on a tractor switch or ammeter. The brown wire may be grounded or connected to the negative battery post. See figures 9 and 10.
IMPORTANT: This sprayer should be connected to 12 volt batteries only!
PUMP SWITCH QUICK COUPLER
RED | RED | + |
| ||
|
| BATTERY |
BROWN | BROWN |
|
FIGURE 9
NEVER ALLOW NEGATIVE PIN ON
PLUG TO COME IN CONTACT WITH
POSITIVE "HOT" POST ON BATTERY.
FIRE OR EXPLOSION MAY RESULT!
PLUG | + | POSITIVE | |
"HOT" | |||
| |||
|
| POST |
| NEGATIVE |
NEGATIVE PIN | POST |
| |
| 12 VOLT TRACTOR BATTERY |
FIGURE 10
6