6.Assemble a 2.38" long spacer, a 3/4" flat washer, the middle brace, a 3/4" flat washer and a 3.90" long spacer onto the long end of the shaft.The bent lip of the middle brace must face the short end of the shaft.Next assemble a double spool assembly, a 5.29" long spacer, another double spool assembly, a 1.00" long spacer and a 3/4" flat washer onto the shaft. See figure 4.

2.38" LONG

MIDDLE

BRACE

SPACER

 

3.90" LONG SPACER

LONG END

OF SHAFT

3/4" FLAT

3/4" FLAT

WASHER

WASHER

 

5.29" LONG SPACER

1.00" LONG SPACER

FIGURE 4

7.Rotate the wheel bracket fastened to the middle of the shaft so that it is pointing upward. Assemble an end plate, a 3/4" flat washer and a second wheel bracket onto the long end of the shaft. Point this wheel bracket as shown in figure 5. Secure it to the shaft using a 1/4" x 1-3/4" hex bolt and 1/4" nylock nut. Tighten. Repeat on short end of shaft.

MIDDLE WHEEL BRACKET

POINTING UP

1/4" x 1-3/4"

HEX BOLT

3/4" FLAT 1/4" NYLOCK NUT WASHER

FIGURE 5

8.Assemble a wheel to a wheel bracket using a 1/2" x 3- 1/2" hex bolt, a 1/2" jam nut and a1/2" nylock jam nut. Adjust the nuts so that the wheel is held securely but will spin freely. Repeat on other side. See figure 6.

1/2" NYLOCK JAM NUT

1/2"JAM NUT

1/2" x 3-1/2"

HEX BOLT

FIGURE 6

9.Assemble the hitch bracket to the tongue using two 3/8" x 1" hex bolts and 3/8" nylock nuts. Tighten. See figure 7.

10.Assemble the hitch pin through the hitch bracket and the tongue. Secure it with the hair cotter pin. See figure

7.

HITCH

3/8" x 1"

HEX BOLT

PIN

 

3/8" NYLOCK NUT

HAIR COTTER PIN

FIGURE 7