11.Assemble the tongue to the tray, placing the slot's locking notch to the front. Use two 3/8" x 1" hex bolts, two 3/8" x 1-1/4" hex bolts, four 1/4" long spacers, and four 3/8" nylock nuts as shown in figure 8. Tighten.

12.Assemble two 3/8" x 1-1/4" hex bolts, four 1/4" long spacers and two 3/8" nylock nuts to the holes on the right side of the slot in the tray. Tighten. See figure 8.

3/8" x 1"

3/8" x 1-1/4"

HEX BOLT

HEX BOLT

3/8" x 1-1/4"

 

HEX BOLT

 

1/4" LONG SPACERS

3/8" NYLOCK NUT

FIGURE 8

13.Place the tray between the end plates. Temporarily insert three 5/16" x 3/4" hex bolts to hold the tray and end plates together at the corners. Leave one upper corner empty. See figure 9.

14.Rotate the middle brace up against the tongue, aligning it with the holes that are closest to the slot in the tray. Fasten the brace to the tongue using two 3/8" x 1" hex bolts and 3/8" nylock nuts. Do not tighten till step 18.

See figure 9.

3/8" x 1"

5/16" x 3/4"

HEX BOLT

HEX BOLT

(Temporary)

 

MIDDLE

BRACE

3/8" NYLOCK NUT

FIGURE 9

15.Fasten the end plates to the corners of the tray using eight 5/16" x 3/4" hex bolts and 5/16" nylock nuts. Do not tighten till step 18.

5/16" x 3/4"

HEX BOLT

5/16" NYLOCK NUT

FIGURE 10