ENGLISH
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2)7/16" Open End or Box End Wrenches
(2)1/2" Open End or Box End Wrenches
All loose parts are shown on page 2. Fasteners in the parts bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the carton and verify that all the parts and fasteners shown on pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note: Righthand(R.H.)andlefthand(L.H.)aredetermined from the operator's position while seated on the tractor.
1.(Figure 1) Each brush assembly has one brush retainer marked with either red or black ink. Lay out the brush assemblies as shown so that the brush retainers marked with ink are in the middle with the red one on the right and the black one on the left.
OVERLAP BRISTLES | 1 |
BRUSH RETAINER
MARKED RED
BRUSH RETAINER
MARKED BLACK
IMPORTANT:Theoverlapbristlesatthebottomofeachbrush help support the back side of the brush for better sweeper performance. Be sure the sweeper is turned as shown in figures 2 and 3 to correctly assemble the brushes.
2.(Figure 2) Attach the brush assembly with the red brush retainer to the right end of the brush shaft using two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The brush retainer marked with red ink must be placed to the middle of the sweeper.
2
1/4" NYLOCK NUT (I)
BRUSH RETAINER MARKED RED
1/4" x 1" 
HEX BOLT
(G)
OVERLAP
BRISTLES
BRUSH RETAINER
MARKED RED
5