If you are using extension brackets:

6.Attach the extension brackets to the legs of the spreader frame. Use two 5/16" x 2" hex bolts and 5/16" nylock nuts per bracket. Tighten. See fi gure 4.

8.Attach the spreader's mounting brackets to the vehicle's rear rack using four 5/16" x 1-3/4" carriage bolts, mounting clamps and plastic knobs. Use the adhesive pads to protect the rack. See fi gure 6.

5/16" x 2"

HEX BOLT

MOUNTING

BRACKET

FIGURE 6

PLASTIC KNOB

MOUNTING

CLAMP

5/16" x 1-3/4"

CARRIAGE BOLT

ADHESIVE PAD

 

EXTENSION

5/16" NYLOCK NUT

BRACKET

FIGURE 4

If you are using extension brackets:

7.AttachtheR.H.mountingbrackettotheextensionbracket shown in fi gure 5 using two 5/16" x 1" hex bolts and 5/16" nylock nuts. Tighten. Repeat on the other frame leg with the L.H. mounting bracket.

5/16" x 1"

HEX BOLT

5/16" NYLOCK

NUT

MOUNTING

BRACKET, R.H.

FIGURE 5

9.Insert the 1/8" hairpin agitator into the middle hole in the spreader shaft. Assemble a seal (turned as shown in fi gure 7) onto the end of the spreader shaft closest to the hairpin agitator. See fi gure 7.

10.Slide the end of the spreader shaft having the seal through the plastic bushing in the bottom of the hopper. See fi gure 7.

11.Slide the impeller onto the spreader shaft and secure it with a 1/8" x 1-1/4" cotter pin. See fi gure 7.

1/8" HAIRPIN

AGITATORSPREADER SHAFT

SEAL

IMPELLER

1/8" x 1-1/4"

COTTER PIN

FIGURE 7

5