CUSTOMER RESPONSIBILITIES
INNER NUT | CLUTCH CABLE ADJUSTMENT |
•Remove four screws from Rear Drive Cover. Lay aside cover and screws.
•Place Clutch Lever in "DISENGAGED" position
•The Cable should be under slight tension but should
not pull the Clutch Lever more than 1/8" away from the Switch Body.
NOTE: If the Plunger extends more than 1/8" out from
OUTER NUT the switch body, the cable tension is too tight and the Engine will not start.
TO INCREASE CABLE TENSION
•Place Blade Clutch Lever in the "DISENGAGED" position.
•Loosen the inner nut on the Clutch Cable.
• Tighten the outer nut on the Clutch Cable.
TO DECREASE CABLE TENSION
| • Place Blade Clutch Lever in the "DISENGAGED" | |
| position. | |
| • Loosen the outer nut on the Clutch Cable. | |
SWITCH | • Tighten the inner nut on the Clutch Cable. | |
• Repeat the above procedure until you have the | ||
BODY | ||
correct tension. | ||
|
CL
•
•
•
NO the En
TO
•
•
•
TO
•
•
•
•
|
| IDLER |
| ENGINE | PULLEY |
|
| |
1/8" | PULLEY |
|
|
| |
PLUNGER |
|
|
CLUTCH LEVER | BLADE |
|
PULLEY |
| |
|
| |
| FOUR |
|
| SCREWS |
|
REAR DRIVE |
|
COVER | CLUTCH LEVER |
19