Agri-Fab 45-03071, 45-03072, 45-0361, 45-03611 INSTALL TOWBAR TUBE TO REAR QUADRANT, INSTALL WIRE HARNESS TO ENGINE, INSTALL CLUTCH TO TOWBAR TUBE, NOTE:

ASSEMBLY

•Remove Hex Bolts and lift Front Drive Cover from mower housing.

•Rest end of Tow Bar Tube on front edge of mower.

•Feed Wire Harness in end of Tow Bar Tube through large hole in back wall of Rear Quadrant.

•Place Towbar Tube into Rear Quadrant, align holes and insert 3/8 x 2-3/4 Hex Bolt through quadrant and rear hole of Tube.

•Secure tightly with 3/8 Hex Lock Nut and then loosen 1/4 turn to allow Tube to pivot freely inside Rear Quadrant.

•Assemble a 3/8 Flat Washer onto a 3/8 x 2-3/4 Hex Bolt.

•Insert Bolt and Washer into slot in Rear Quadrant and into hole in Towbar Tube.

•Secure Tightly with 3/8 Flat Washer and 3/8 Hex Lock Nut, then loosen 1/4 turn to allow Tube to pivot freely inside Rear Quadrant.

NOTE: Towbar Tube must pivot freely inside Rear Quadrant when Latch is pulled from notch.

•Feed Wire Harness up through hole in middle of Front Drive Cover.

•Install one Wire to Engine Magneto Ground Terminal. (The same Terminal as red Wire from inside Mower.)

•Install other Wire of Wire Harness to Engine Ground Base. (The same Terminal as black Wire from inside Mower.)

•Refasten Front Drive Cover to mower housing.

•Place Clutch Cable forward along Towbar Tube.

•Spread ends of three Cable Clips and place around Clutch Cable.

•Place Clutch Cable on top of Towbar Tube and align Cable Clips with bolt holes in Towbar Tube.

•Secure with three #10 Screws.