9.Assemble a spacer (P), a 3/4" flat washer (K), a wheel (air valve facing out) and another 3/4" flat washer (K) onto the end of the axle that has both the large and small holes. See figure 4.

10.Install a 1/8" x 1-1/2" cotter pin (M) into the small hole in the end of the axle. See figure 4.

11.Open the bail on the drive pin (V) and install it through the wheel and the large hole in the axle. Close the bail to lock the pin in place. See figure 4.

(V) DRIVE PIN

(M) 1/8" x 1-1/2"

COTTER PIN

AIR VALVE

(P) SPACER

 

(K)3/4" DIA.

FLAT WASHER

FIGURE 4

12.Turn the spreader upright on its wheels.

13.Assemble the flow control mounting tube to the hitch tube using two 5/16" x 1-3/4" hex bolts (A) and 5/16" hex lock nuts(G). DO NOT TIGHTEN YET. See figure

5.

14.Assemble the vinyl cap (S) onto the flow control mounting tube. See figure 5.

(S)VINYL CAP

(A)5/16" x 1-3/4"

HEX BOLT

(G) 5/16"HEX

LOCK NUT

FIGURE 5

15.Assemble the flow control mounting bracket and the tube support strap to the flow control mounting tube using two 5/16" x 1-3/4" hex bolts (A), four 5/16" washers (J) and two 5/16" hex lock nuts (G). DO NOT TIGHTEN YET. See figure 6.

16.Remove the preassembled bolt and nut from the front of the hopper. Attach the tube support strap to the hopper and hopper strap using the bolt and nut you removed. TIGHTEN the nut and bolt. See figure 6.

PREASSEMBLED

BOLT AND NUT

HOPPER

STRAP

TUBE

SUPPORT

STRAP

OFF

ON

2

1

 

3

 

4

 

5

 

6

 

7

 

8

 

9

 

10

(G) 5/16" HEX

(J) 5/16"

FLAT WASHER

LOCK NUT

(A) 5/16" x 1-3/4"

 

 

HEX BOLT

FIGURE 6

 

17.TIGHTEN the two bolts which fasten the flow control mounting tube to the hitch tube. DO NOTTIGHTEN the two bolts which fasten the flow control mounting bracket to the flow control mounting tube.