23.Place the adjustable stop (S) into the "ON" end of the slot in the top of the flow control mounting bracket. Secure with the 1/4" x 3/4" carriage bolt (F), a nylon washer (J), a 5/16" flat washer (K) and the nylon wing nut (R). See figure 12.
(R) NYLON |
|
|
|
WING NUT |
|
|
|
(K) 5/16" FLAT |
|
| ON |
WASHER | 4 | 3 | 1 |
|
| 2 |
|
| 5 |
|
|
| 6 |
|
|
(J) NYLON | 7 |
|
|
10 |
|
| |
| 8 |
|
|
| 9 |
|
|
WASHER |
|
|
|
(S) ADJUSTABLE 
STOP
(F) 1/4" x 3/4"
CARRIAGE BOLT
FIGURE 12
24.Slide the adjustable stop to the end of the slot. Move the flow control arm against the stop. Assemble the spring
(X) to the flow control mounting bracket and then to the
flow control rod. See figure 13.
25.Position the flow control mounting bracket (figure 14).
a.Push flow control arm to "OFF" position.
b.Slide flow control mounting bracket along tube until closure plate in bottom of hopper just closes.
c.Snug the 5/16" lock nuts just enough to hold flow control mounting bracket in place.
d.Set adjustable stop at "5". Pull flow control arm against stop. Verify that closure plate has opened about half way.
e.If closure plate does not open half way, adjust position of flow control mounting bracket until closure plate will open about half way at "5" and will still close when arm is locked in "OFF" position. Tighten the 5/16" lock nuts.
OFFON
FLOW | OFF |
CONTROL |
|
ARM |
|
3 |
|
4 |
|
5 |
|
6 |
|
7 |
|
8 |
|
9 |
|
10 |
|
ADJUSTABLE STOP (S) (SETTING "5")
FIGURE 14
(X) SPRING
OFF
FLOW
CONTROL
ROD
ON
1 2 
3 
4 
5 
6 7 
8 9
10 
26.Place the screen down into the hopper, sliding the edge of the screen under one of the clips. Slightly bow the screen to slide the opposite side of the screen under the other clip. See figure 15.
FIGURE 13
CLIPS
FIGURE 15
7