REFER

TO

CHARTS

OVERLAP

FIGURE 18

IMPORTANT: Application rates shown in the chart are affected by humidity and by the moisture content of the material (granular and pellet). Some minor setting adjustments may be necessary to compensate for this condition.

APPLICATION CHART

TYPE

 

SPREAD

MATERIAL

FLOW SETTING

WIDTH

 

 

 

FERTILIZER

 

 

Powder

3 - 5

3' - 4'

Granular

3 - 5

8' - 10'

Pelleted

3 - 5

10' - 12'

Organic

6 - 8

6' - 8'

GRASS SEED

 

 

Fine

3 - 4

6' - 7'

Coarse

4 - 5

8' - 9'

ICE MELTER

6 - 8

10' - 12'

 

 

 

OPERATING SPEED - 3 MPH. (100 ft. in 23 seconds)

CHECK TIRE INFLATION

3.Check if tires are adequately inflated before each use.Do not inflate beyond maximum recommended pressure.

CAUTION: DO NOT inflate tires beyond the maximum recommended pressure printed on side of tire.

CLEANING

4.Rinse inside of hopper and exterior of spreader and dry off before storing.

LUBRICATE (See figure 19)

5.Lightly apply automotive grease as needed to the sprocket and gear.

6.Oil the nylon bushings on the vertical sprocket shaft and on the axle at least once a year, or more often as needed.

7.Oil right hand (idler) wheel bearing at least once a year or more often as needed.

OIL

OIL

GREASE

FIGURE 19

STORAGE

1.Rinse inside of hopper and exterior of spreader and dry off before storing.

2.Store in a clean, dry area.

MAINTENANCE

CHECK FOR LOOSE FASTENERS

1.Before each use make a thorough visual check of the spreaderforanyboltsandnutswhichmayhaveloosened. Retighten any loose bolts and nuts.

CHECK FOR WORN OR DAMAGED PARTS

2.Check for worn or damaged parts before each use.

Repair or replace parts if necessary.

SERVICE AND ADJUSTMENTS

1.If the axle, slotted gear and sprocket assembly is disassembled, mark down the positions of the parts as they are removed.The drive wheel and sprocket positions in relation to the slotted gear determine which direction the spreader plate will spin.Be sure to reassemble them in their original positions. (Refer to figure 4 on page 5.) Use shim washers (Ref. no. 21 on pages 10 and 11) as needed for minimum backlash. Add grease to gear and sprocket.

9