4.Attach the weight bracket to the tray using a 3/8" x 1" bolt (H) and 3/8" nylock nut (I). Do not tighten yet. See figure 4.

5.Assemble the straps to the holes in the weight bracket and the tray that are aligned. Use two 1/2" x 2-1/4" bolts (B), .75" spacers (O) and 1/2" nylock nuts (J). Do not tighten yet. See figure 4.

4

B O

H

WEIGHT

I BRACKET

J

STRAP

9.Attach the four axle support brackets to the tray using eight 3/8" x 1" hex bolts (H) and 3/8" nylock nuts (I). Do not tighten yet! See figure 6.

6

AXLE

H SUPPORT

BRACKETS

I

6.Attach the mast extension straps to the front of the tray using two 1/2" x 1-1/4" bolts (C) and 1/2" nylock nuts

(J). Do not tighten yet. See figure 5.

7.Assemble the mast sides to the straps using the 1-1/2" spacer (P), 1/2" x 3-1/2" hex bolt (A) and 1/2" nylock nut (J). Do not tighten yet. See figure 5.

8.Tighten all loose nuts assembled through step 7.

P5

J

STRAP

 

MAST

SIDE

A C

J

MAST

EXTENSION

STRAP

10.Secure the axles to axle support brackets using two washers (K) and 1/8" x 1-1/2" cotter pins (L) at the ends of each axle. See figure 7.

11.Tighten the four axle brackets assembled in step 10.

See figure 7.

12.Add grease to the spool assemblies through the grease fittings until grease is forced out the ends of the spool tubes. See figure 7.

7

GREASE

FITTING

K

L