Aiphone IS-SS-HID-I Wiring Diagram, Testing & Operation, Specifications, Card Reader, Door Unit

WIRING DIAGRAM:	IS-MV		IS-CCU
		CAT-5e	IS-PU-UL
IS-SS-HID-I
		CAT-5e

NO

COM

NC

To Strike

& Power

TESTING & OPERATION:

Connect the reader to the host according to the wiring table below and the host installation guide.

Wiegand Wire	Color
+ DC (10-16V)	Red
Ground	Black
Data0	Green
Data1	White
Shield Ground	Drain
Green LED	Orange
Red LED	Brown
Beeper	Yellow
Hold	Blue
---	Violet

•When power is applied to the iCLASS® reader, the LED will turn RED while the beeper beeps simultaneously 3 times (the last tone is a higher frequency). The LED will then flash once after the last tone. This indicates that the microcontroller is operating properly.

•Present an iCLASS ID card to the reader (hold card directly in front of reader). The LED will momentarily turn green while the beeper beeps once, indicating that the card was read successfully.

SPECIFICATIONS:

CARD READER:		DOOR UNIT:
Reader type:	R10 (Rev. C)	Terminations:	RJ45 jack for audio/video
Power Source:	10 ~ 16V DC		Screw terminals for door release
Current:	80mA (Avg); 300mA (peak)	Operating Temp:	14° ~ 140°F / -10° ~ 60°C
Transmit Freq.	13.56 MHz	Wiring Distance:	980’ with Cat5e/6 cable
Terminations:	Color-coded pre-wired pigtail	Dimensions:	12-3/8” H x 7” W
Wiring Distance:	500’	w/SBX-ISDVFP:	12-13/16” H x 7-1/16” W x 2-13/16” D
Operating Temp:	14° ~ 140°F / -10° ~ 60°C		(top), 1-13/16” D (bottom)
Operating Humidity:	5-95% relative humidity
	non-condensing

Aiphone Corporation

1700 130th AVE NE

Bellevue, WA 98005

(425)455-0510 Fax: (425) 455-0071

FCC WARNING:

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference that may cause undesired operation.

•For proper regulatory compliance, the drain wire should be disconnected at the power supply end of the cable.

•Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

•The Reader is intended to be powered from a limited power source output of a previously certifed power supply

TOLL FREE TECHNICAL SUPPORT:

(800) 692-0200

E-MAIL: tech@aiphone.com

Pg. 2 IS-SS-HID-I Instr. 0311JD