Aiphone specifications KCS-IFA Set includes KC-IFA, KC-DAR, PS-2420UL, NVS-410, VIP10, Brand

KC-IFA

Network Video Interface Adaptor

KCS-IFA Set includes:

KC-IFA, KC-DAR, PS-2420UL

- INSTRUCTIONS -

The KC-IFA is a network video interface adaptor that allows the Aiphone color video door station to be connected through a video server (not supplied by Aiphone) to any PC connected to a LAN or WAN network. This provides audio and video identification and access control for a person at the camera location, answered from a PC.

DOOR STATION INSTALLATION:

1.The KC-DAR should be mounted between 48-52" above finished floor, or at optimum height for the application. (See illustrations below.)

2.Install KC-DAR to 1-gang box or ring, or directly to wall surface with appropirate hardware.

3.Use 2 conductor, 18AWG non-shielded wire from KC-DAR to KC-IFA. (Aiphone #871802)

Mounting height

Back frame Single-gang box

KC-DAR

83.5mm

(3-5/16")Unit center

150cm (5')

50cm

250cm (8'3")

130cm (4'3")

Screws supplied (2)

Tamperproof screw & cover

(20")

The KCS-IFA System interfaces with a Network Video Server.

Aiphone has evaluated and approved the following manufactures’ products for use with the KC-IFA:

BRAND:	MODEL:	NOTES:	NVS-410
Inscape Data	NVS-410	Two relay outputs (One for door release)
http://www.inscapedata.com/pdf/nvs410.pdf		Software Included
			VIP10
VCS	VIP 10	One relay output for door release

http://www.controlware.de/cwp/daten/PDFs/Datenblatt_VIP10.pdf

NOTE: RS232 programmable relay controller can be interfaced with most video servers to control The Tilt function of the video door station. Contact Technical Support for more information.

TERMINAL DEFINITIONS:

A1/A2:	KC-DAR Connection
+/-:	DC 24V Input
BNC Connector:	Video Output
NO,NC,COM:	Call-in Output
OUT/GND:	Audio Output
IN/GND:	Audio Input
UP:	Tilt Control Up (“Lo” active)
DN:	Tilt Control Down (“Lo” active)
GND:	Tilt Control Ground

SPECIFICATIONS:
Power Source:	24VDC, 1A
Consumption	400mA, Max.
Video Out:	NTSC, 1Vp-p
Audio In:	10k Ohm
Audio Out:	600 Ohm
Call-in Signal:	N/O – COM – N/C, 24V DC@ 1A
	(Present at .5 sec.; adjustable to 30 sec.)
Tilt Up/Down:	TTL/CMOS low level control
Weight:	4.3 lbs
Dimensions:	1.7"H x 7.9"W x 9"D
KC-DAR to KC-IFA:	2 parallel wires, non-polarized (#871802)
	22 AWG = 165', 18 AWG = 330'
	Pg. 1