Aiphone RY-24L manual Instructions, Installation, Wiring Diagrams, Electric Strike, Wiring Method

JA-2MECD

JA-2MCD

RY-24L

Form C Door Release Relay for AX, KB, KC, and JA Color Video Systems

- INSTRUCTIONS -

The RY-24L Door Release Relay Module is an interface between the door release contact on the Aiphone monitor and the actual release mechanism. The contact closure directly out of the monitor is rated at 12V AC with a low current capacity. If your strike or maglock requires more voltage or current, the RY-24L is required. It provides either a Normally Open contact for an electric strike, or a Normally Closed contact for a magnetic lock. The contact rating supports a majority of door release hardware available on the market. The RY-24L relay is recommended with all AX, KC, KB, and JA video systems when using the door release feature. This will protect the built-in contact from possible surge damage.

(Note: For more than one door release on the KB system, use the RY-3DL.)

INSTALLATION:

1.Install in a suitable location, either near the power source for the door release mechanism, or behind the monitor.

2.Secure wire connections with proper termination, such as wire nuts or crimp connectors.

3.Trim the wires to the desired length.

4.Trim the unused contact wire so the bare strands are not exposed.

WIRING DIAGRAMS:

JA System Wiring

RED: L/ORG

BLK: (-) Neg.

BRN: Common

ORG: N/O

YEL: N/C

RY-24L COLOR CODE:

Input of Relay:

Red:	L/ORG, Postive trigger
Black:	(-) NEGATIVE
Output of Relay:
Brown:	COMMON
Orange:	N/O Contact
Yellow:	N/C Contact

(See contact rating specs on back page)

Door 1

JA-DAC

Door 2

JA-DAC

A1

A2

A1 A1

A2 A2

A1

A2

DOOR 1	SUB
DOOR 2

B1

B2

ELECTRIC STRIKE	Door
WIRING METHOD:	Release
(Normally Open contact)	#1

Door

Release

#2

MAGNETIC LOCK

WIRING METHOD:

(Normally Closed contact)

LOCK

POWER

RY-24L
	Brn	COM
	Org
		N/O
	Yel
		N/C
LOCK
POWER
RY-24L
		Blk
	Blk	Red
Brn
	Red
Org
Yel

	ADAPTER 1
C1
C2
	ADAPTER 2
C1
C2

#1

Purp

Blu

Grn

Yel

Org

Red

Brn

#2

L1 (Brn)

L1 (Red)

L2 (Org)

L2 (Yel)

PS-2420UL

+	+
-	-

Connect RED and YELLOW wire on JA--2MCD/-2MECD directly to +

NOTE: The door release contacts are rated at 24V AC, 500mA. The RY-24L should be used in any application where the strike or maglock has a higher voltage or draws more current. Otherwise, internal damage to the JA monitor could result.

Page 1