Air King B600 installation instructions Replacement Parts Diagram, Section

2.Using the included 8-32 screws and washers, mount the blower in place and tighten all screws. Confirm that the blower is securely seated in place and there are no air gaps around the blower gasket.

3.Plug both the 3 wire and 4 wire quick connect cords from the blower into the appropriate receptacles located on the inside front of the hood canopy. These cords will only fit into the receptacles one way (Figure 2).

4.Plug both the 3 wire and 4 wire quick connect cords from the blower into the appropriate receptacles located on the inside front of the hood canopy. These cords will only fit into the receptacles one way (Figure 2).

5.Reinstall the rear bottom plate by fitting the back edge of the plate into the channel located on the back of the hood and reinstalling the two screws and washers removed in Step 1 (Figure 4).

	Receptacles	Screw
		Washer
		Channel
Figure 2	Blower	Bottom Plate
		Figure 4
SECTION 3

Installation into 10" High Canopy SECTION 4

1. Remove the rear bottom plate of the hood canopy. It is secured in place		Finishing the Installation
	with a screw and washer on either side (Figure 3).	1. Install the included fuse into the electrical panel by turning the fuse cap
	Screw	counter clockwise and pulling out. Insert the included 1/4" x 1-1/4" time
		delay fuse in the holder and reinstall into the panel (Figure 5).
	Washer
		Cap
	Bottom Plate	Fuse
	Figure 3
2.	Lift blower up into the hood canopy and slide the keyhole slots in the blower	Figure 5
	mounting flange over the two studs of the hood. Slide the blower into place

and tighten the hex nuts on the mounting stud while lining up the 8 holes	NOTE: If you need to replace the fuse, replace with a 1/4" x 1-1/4" Bussman
in the blower mounting flange to the 8 screw studs of the hood (Figure 1).
	MDA-3 or equivalent 3 amp, 250V ceramic, time delay fuse only.
3. Using the included 8-32 screws and washers, mount the blower in place
	2.	Refer to the hood instruction manual to complete the installation, for
and tighten all screws. Confirm that the blower is securely seated in place
		maintenance, and before restoring power.
and there are no air gaps around the blower gasket.
	3.	The blower is covered under the range hood’s warranty.

REPLACEMENT PARTS DIAGRAM

#	Qty.	Description	Replacement Part #
1	1	Blower Assembly	5S1136063
2	1	Blower Gasket	5S1136100
3	8	Grommet	5S1136101
4	8	Washer	5S1136102
5	8	8-32 Screw	5S1136103	8
6	1	Capacitor	5S1136104
7	1	Screw	5S1136105
8	1	Fuse	5S1136106
				5

3

4

2

6

7

1

111597005 New 3-07 www.airkinglimited.com 2 of 8