Lamp Holder
Night Light
Figure 11
6.Reinstall the glass lens in place by inserting the two tabs connected to the light lens into the holes in the grill and applying upward pressure until the lens fits snugly into place (Figure 12).
Lens |
Hole |
Figure 12 |
7. Restore power and test your installation.
SECTION 7
Use and Care
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT.
1.Cleaning the Grill: Refer to instructions in Section 6 Completing the Installation, to remove grill and glass light lens. Use a mild detergent, such as dishwashing liquid, and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS. Completely dry all parts before reinstalling. Refer to instructions in Section 6 Completing the Installation, to reinstall grill and glass light lens.
2.Cleaning the Fan Assembly: Unplug the motor cord and light cord from receptacles and loosen the venturi screw to remove the venturi from the unit. Wipe all parts with a dry cloth or gently vacuum the fan. NEVER IMMERSE ELECTRICAL PARTS IN WATER. Refer to instructions in Section 6 Completing the Installation, to reinstall venturi.
CAUTION: ALLOW BULB TO COOL BEFORE REPLACING
3.Changing the Light Bulb: Disconnect power to the unit. Remove the glass light lens from the grill by pulling downward on the lens. It is held in place with hidden tabs on either side of the lens. It might be necessary to carefully insert a putty knife or screwdriver into one of the indentations around the light lens to help release the lens from the grill (Figure 9). Replace main light bulb with 100 watt maximum, type A19 medium base incandescent bulb. Replace night light bulb with 7 watt maximum, type C7 (candelabra base) incandescent bulb. Reinstall the glass lens in place by inserting the two tabs connected to the light lens into the holes in the grill and applying upward pressure until the lens fits snugly into place (Figure 12).
210572064 Rev. A | www.airkinglimited.com | 4 of 12 |
