Airlink101 AGSW502 Connecting the Switch, Section, Front Panel LED Indicators, Rear Panel, Ports

Front Panel

LED Indicators

LED		Color	Status		Description
PWR	Green		On		The switch is powered on.
			Off		The switch is powered off.
		Green	On		LAN port is connected.
			Off		LAN port is not connected.
		(10/100M)
LNK/ACT			Flashing	Transferring or receiving data.
		Yellow	On		LAN port is connected.
			Off		LAN port is not connected.
		(10/100/100M)
			Flashing	Transferring or receiving data.

Rear Panel

Ports

Item Name	Description
Power	Power connector, DC 12V / 1A.
1 - 5	10/100/1000Mbps LAN ports 1 to 5.

Section 2

Connecting the Switch

Note: Operating Environment

This switch must be installed and operated within the limits of specified operating temperature (32~1040F) and humidity (0~90% Non-condensing). Do not place objects on top of the unit. Do not obstruct any vents at the sides of the unit. Do not position the unit near any heating source such as heater, radiator, or direct exposure to sun. Prevent entering of water and moisture into the unit. If necessary, use dehumidifier to reduce humidity.

Step 1 Connecting to network devices

The RJ-45 ports on the switch support Auto-MDI/MDI-X function which allows using straight-through or cross-over type cables to connect this switch to workstation or hub.

Connect one end of the network cable to the RJ-45 port on the rear panel, and connect the other end of the network cable to the RJ-45 port on the network device. Follow the same procedure to connect all the RJ-45 ports of the switch. The UTP network cables must be four pairs Category 5 or above for 1000Mbps data transmission; two pairs Category 5 for 100Mbps data transmission; two pairs Category 3, 4 or 5 standards for