Section 1Getting Started
Note: Before using the IP Camera, you’ll need to perform the following tasks:
1. Connect the IP Camera to your network.
2. Install the Setup Wizard.
3. Gather information about your local network address.
4. Configure the IP Camera using the Setup Wizard.
Please follow the steps in this Guide carefully to ensure proper setup of the IP Camera.
Step 1 Connect one end of a network cable to the IP Camera and connect the other end to one of the
LAN ports of the router or switch (See the diagram below).
Step 2 Power on the IP Camera by connecting one end of the supplied power adapter to the power jack
of the Camera and connecting the other end to an electrical outlet.
Step 3 Verify that all the lights on the Camera are lit. If not, verify that all the connections are secure and
try again.
This Quick Installation Guide only provides the basic instructions. For more
detailed information, please refer to the User’s Manual in the supplied CD.
Caution: The IP Camera is designed for indoor use only. Direct exposure to sunlight may cause
permanent damage to the CMOS sensor. When operating in extremely bright environment, an iris
lens or sun visor is recommended to protect the IP Camera.