Preamble Type | The “Long Preamble” can provide better |
| wireless LAN compatibility while the “Short |
| Preamble” can provide better wireless LAN |
| performance. |
IAPP | If you enable “IAPP”, it will allow wireless station |
| roaming between IAPP enabled access points |
| within the same wireless LAN. |
Protection | This is also called CTS Protection. It is |
| recommended to enable the protection |
| mechanism. This mechanism can decrease the |
| rate of data collision between 802.11b and |
| 802.11g/802.11n wireless stations. When the |
| protection mode is enabled, the throughput of |
| the AP will be a little lower due to many of frame |
| traffic should be transmitted. |
Aggregation | This function is used to join multiple data |
| packets for transmission as a single unit to |
| increase network efficiency. |
Short GI | The 802.11n draft specifies two guard intervals: |
| 400ns (short) and 800ns (long). Support of the 400ns |
| GI is optional for transmit and receive. Enable this |
| function will increase network efficiency. |
WLAN Partition | Enable this function and all the wireless clients cannot |
| access to each other. |
RF Output Power | You can set the output power of wireless radio. |
| Unless you’re using this wireless router in a |
| really big space, you may not have to set output |
| power to 100%. This will enhance security |
| (malicious / unknown users in distance will |
| not be able to reach your wireless router). |
Click <Apply Changes> at the bottom of the screen to save the above configurations.
3.2.5 Wireless Schedule
This page allows you to set up the wireless schedule rules. You can designate to enable wireless interface by time or day.
59
