27
IDE Hard Disk Interface
The 586IVX system board is equipped with two shrouded PCI IDE
headers that will interface four Enhanced IDE (Integrated Drive Elec-
tronics) hard disk drives.
Note:
Only Enhanced IDE hard drives or ATAPI CD-ROMs can be connected
to the IDE interface.
Connecting the IDE Hard Disk Interface
To prevent improper IDE cable installation, each shrouded PCI IDE
header has a keying mechanism. The 40-pin connector on the IDE
cable can be placed into the header only if pin 1 of the connector is
aligned with pin 1 of the header.
Floppy Disk Drive Controller
The 586IVX system board is equipped with a shrouded floppy disk
header that supports two standard floppy disk drives. You can install
any 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB floppy disk drives. To
prevent improper floppy cable installation, the shrouded floppy disk
header has a keying mechanism. The 34-pin connector on the floppy
cable can be placed into the header only if pin 1 of the connector is
aligned with pin 1 of the header.
Connecting the Floppy Disk Cable
1.Install the 34-pin header connector into the shrouded floppy disk
header (J10) on the system board. The colored edge of the ribbon
should be aligned with pin 1 of connector J10.
2.Install the other 34-pin header connector(s) into the disk drive(s).
Align the colored edge of the daisy chained ribbon cable with pin 1
of the drive edge connector(s). The end-most connector should be
attached to the drive you want to designate as Drive A.