43
IRQ3-IRQ15 (Wake Up Events in Doze & Standby and PowerDown & Resume Events)
These are I/O events whose occurrence can prevent the system from
entering a power saving mode or can awaken the system from such a
mode. In effect, the system remains alert for anything which occurs to a
device which is configured as enabled, even when the system is in a
power saving mode.
When an I/O device wants to gain the attention of the operating system,
it signals this by causing an IRQ to occur. When the operating system
is ready to respond to the request, it interrupts itself and performs the
service.
PNP/PCI Configuration
This section describes configuring the PCI bus system. It covers some
very technical items, and it is strongly recommended that only experi-
enced users make any changes to the default settings.
ROM PCI/ISA BIOS
PNP/PCI CONFIGURATION
AWARD SOFTWARE, INC.
Resources Controlled By
Reset Configuration Data : Auto
: Disabled
ESC
F1
F5
F6
F7
:Quit
:Help
:Old Values
:Load BIOS Defaults
:Load Setup Defaults
↑↓→←
PU/PD/+/-
(Shift) F2
:Select Item
:Modify
:Color
PCI IRQ Actived By : Level
PCI IDE IRQ Map To : PCI-AUTO
Primary IDE INT# : A
Secondary IDE INT# : B
HDD
Power
Down
This is used to define the continuous HDD idle time that
elapses before the HDD enters the power saving mode (motor
off). When enabled and after the set time of system inactivity,
the hard disk drive will be powered down while all other de-
vices remain active.