CDCX517MX417/X317(YU)-total-En-4
3
ENGLISH
3
ENGLISH

Adjusting sound

You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass)
1Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode’s indicator flashes.
2Turn the Smart Jog to increase or decrease the level
for the selected mode (except for H-BASS).
In H-BASS mode, turn the Smart Jog to select on or
off.
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.

Aligning the source levels

(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode’s
volume to almost the same level.
1Press FNC repeatedly to select the desired mode.
2Press DISP while pressing SEL.
“LA 0” appears in the display.
3Turn the Smart Jog to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.

Restoring the factory settings

1Turn off the unit.
2Press and hold DISP until “LA --” appears in the
display.
Note
You can restore the factory settings only for VOL, BASS,
TRE, BAL, FAD, and H-BASS, and aligned source
volume levels.

Muting button beep sounds

1Turn off the unit.
2Press and hold SEL until “bEEP” appears in the
display.
3Turn the Smart Jog to select on (level indicators
appear) or off (level indicators disappear).
4Press and hold SEL until the unit turns off.
Stereo indicator Local indicator

Setting the clock

1Press and hold DISP until the clock indicator flashes
in the display.
2Press TUNEi (to set hour) or TUNEk (to set
minute) and turn the Smart Jog.
3Press DISP.

Displaying the clock

1Press DISP.
To return to the former display, press DISP again.
RADIO OPERATION

Tuning in to a station

(Seek/Manual Tuning)
Band indicator Frequency indication
1Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).
2* Press TUNEi (to move to higher frequencies) or
TUNEk (to move to lower frequencies) to tune in to
a station.
“ST” appears in the display when a station is
broadcasting in stereo, and receiving conditions are
good.
*Seek Tuning and Manual Tuning
•Press and hold TUNEi or TUNEk until seek Tuning
starts.
The unit locates a station automatically (Seek Tuning).
•Press TUNEi or TUNEk repeatedly to search for a
desired station while increasing or decreasing the
frequency step by step (Manual Tuning).
To stop Seek Tuning, press TUNEi or TUNEk
again.
Monaural mode
When signals become weak, or reception becomes
poor, the unit automatically switches to Monaural mode
to reduce noise.
001/CDC-X517M/X417/X317(YU)E 00.12.25, 2:45 PM4