Aiwa NSX-AJ22 manual Setting the Timer, Timer Recording, Adjust the volume, Prepare the source

TIMER

SETTING THE TIMER

The unit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

1Press one of the function buttons to select a source.

2Press TIMER repeatedly until 5 appears on the

display.

When using the remote control, press TIMER while pressing

SHIFT.

Time and audio source name flash alternately.

3Within 6 seconds, turn MULTI JOG to designate

the timer-on time, then press ENTER or a.

Turning MULTI JOG changes both the hour and the minute. for gis also available in place of MULTI JOG. Holding these buttons down will vary the time rapidly.

4Within 4 seconds, turn MULTI JOG to select the

duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5 minute steps.

f or g is also available in place of MULTI JOG.

The duration will be automatically set after 4 seconds. It will also be set if ENTER or a is pressed within 4 seconds after step 4.

5 Adjust the volume.		RECORDING
6 Prepare the source.
	The source sound will play at the volume level set in this step
	when the power is turned on by the timer.
	If the volume level is set to 17 or higher, however, it will
	automatically be set to 16 when the power is turned on.
	To listen to a CD, load the disc to be played first on tray 1.
	To listen to a tape, insert the tape into deck 1 or 2.
	To listen to the radio, select the band and tune in to a station.	TIMER
7 Press POWER to turn off the power.
	When the timer-on time is reached, the unit turns on and
	begins play with the selected source.
You can change the source that was selected in step 1 by pressing
one of the function buttons before pressing ENTER or ain step
3.
To check the timer setting
Press TIMER.
The timer-on time, the selected source, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly so that 5 disappears.
To restore the timer standby mode, press again to display 5.
Using the unit while the timer is set		En
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 and 6.

•Timer playback and timer recording will not begin unless the power is turned off.

•Connected equipment cannot be turned on and off by the built in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press either TUNER BAND or VIDEO/AUX to select a source, then press TIMER repeatedly until 5 REC appears on the

display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6.

•If the timer recording is done with the economizing mode (page 6) set to “ECO ON” or “ECO AUTO” and the power turns off, the dimmer mode will be set to “DIMMER 3” and the volume level will be 0 (minimum level) the next time the power is turned on.

•You cannot use the timer function to record from a CD or tape.

•You can check the timer setting by pressing TIMER even while the power is off. In this case, if you press ENTER or awithin 4 seconds after pressing TIMER, you can enter the timer setting mode and change the previous setting.

ENGLISH 17