C | 1 | 2 |
3 |
|
|
D |
|
|
E |
F 1 |
2 | 3 |
G
USING ON RECHARGEABLE BATTERIES → C
•Be sure to use size AA
•Be sure to read the instructions of the purchased rechargeable batteries before use.
•When using on rechargeable batteries for the first time, charge them until the battery indicator goes out.
•Before charging the batteries, close the disc compartment. You cannot charge the batteries while it is opened.
1Insert the rechargeable batteries with the 0 and 9 marks correctly aligned.
2Connect the AC adaptor.
1 to DC 5 ~ 6 V jack
2 to a wall outlet
3Keep sSTOP/OFF/CHARGE pressed for about 1 second to start charging.
When charging is completed,
After charging, disconnect the AC adaptor.
Time to recharge the batteries
Recharge the batteries when E (red) lights. If the unit remains in use after E (red) lights,
To stop charging
Press a STOP/OFF/CHARGE during charging.
ATTENTION:
The product you have purchased can be powered by nickel cadmium batteries which is recyclable. At the end of their useful life, under various state and local laws, it is illegal to dispose of these batteries into your municipal waste stream.
Please call
USING ON AC HOUSE CURRENT
Connect the supplied AC adaptor in the same way as when recharging the batteries.
During operation on AC house current, all of OPE/BATT indicators light.
BEFORE PLAYBACK
HOLD switch → D
Release the HOLD switch before playback. → a
When not using the unit, set the HOLD switch to the HOLD position. → b Accidentally pressed button will not function.
If buttons are pressed when the HOLD switch is set to the HOLD position, “HOLd” flashes in the display.
Turning on and off → D
Turning the power on
Press e PLAY/PAUSE. Power is turned on and playback starts.
Note
“Err” appears on the display when you play a disc placed
Turning the power off
If no new operations are done within 30 seconds from the end of last operation, the power is turned off automatically. (Auto power off function)
•You can turn off the power by pressing sSTOP/OFF/CHARGE before it is automatically turned off.
Standby mode → D
When an operation finishes, the unit goes into standby mode until the auto power off function automatically turns off the power.
To enter standby mode, press ePLAY/PAUSE to start playback, then press sSTOP/OFF/CHARGE.
Adjusting the sound → E
Volume
Turn the VOL control to adjust the volume.
DSL
Press DSL repeatedly for more powerful sound and deeper bass. : Deep bass is emphasized.
: Deep bass is strongly emphasized. : Normal sound
Signal sound function
You can check the operation by beep sound when you press an operation button. The signal sound function is not activated when you purchase this unit.
To use the signal sound function, press ePLAY/PAUSE while pressing PLAY MODE while in stop mode. The beep sound is heard when you press a button. To cancel the beep sound, repeat this procedure.