8B-HC1-901-11
010109BYG-O9 Printed in Indonesia
A
B
C
Highlighted letters in the text of this manual correspond to the illustrations.
PRECAUTIONS
To maintain good performance
•Do not use the unit in places which are extremely hot, cold, dusty or humid. In particular, do not use or keep the unit in following places.
•in a high humidity area such as a bathroom
•near a heater
•in an area exposed to direct sunlight (e.g., inside a parked car, where it can become extremely hot)
•near sources of strong magnetism, such as televisions, speakers, or magnets
•where there is a lot of movement or vibration, such as on a car dashboard or an unstable shelf
For safety
•Do not attempt to disassemble the unit. Laser rays from the optical pickup are dangerous to the eyes.
•Make sure that pins or other foreign object do not get inside the player.
•Take care not to drop the unit or subject it to strong shocks.
•To keep dust from the pickup lens, keep the disc compartment lid closed after use. Never touch the lens.
•If you hear no sound when playing a disc, DO NOT turn the volume up high because music could suddenly start at high volume. Turn the volume control to the lowest level before starting playback and slowly turn it up to the desired level.
Note on listening with the headphones
•Listen at moderate volumes to avoid hearing damage.
•Do not wear the headphones while driving or cycling. It may create a traffic hazard.
•You should use extreme caution or temporarily discontinue use in potentially hazardous situations, such as walking, jogging, etc.
•Wear them properly; L is left, R is right.
Note on condensation
If the unit is suddenly moved from a cold place to a warm one, it may result in condensation on the pickup lens and malfunction or playback difficulties. Should this occur, leave the unit for a few hours, then try to playback again.
MAINTENANCE
To clean the lens → A
If the lens becomes dirty, the player will skip or not play. If this occurs, clean the lens in the following manner.
To remove dust or dry particles, first use a camera lens blower/brush a to blow a few times to loosen particles, then gently brush the lens b clean. Finish by blowing the lens again.
To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe gently from the center to the edge. Lens cleaning solution is commercially available.
Note
Take care not to get too much solution on the swab, which could flow into the unit and cause damage.
Pressing too strongly with the swab could scratch or break the lens.
To clean the discs → B
Before playing, wipe the disc from the center outward with a cleaning cloth. After playing, store the disc in its case.
SPECIFICATIONS
Tracking system | |
Laser pickup | Semiconductor laser |
D/A conversion | |
Frequency response | 20 – 20,000 Hz |
Output | PHONES/LINE OUT jack (stereo |
Frequency range | AM: 530/531 kHz – 1,710/1,602 kHz |
| (10 kHz/9 kHz steps) |
Maximum output | FM: 87.5 – 108 MHz |
12 mW + 12 mW (16 ohms at 1 kHz) | |
Power supply | 500 mV (47 k ohms at 1 kHz) |
DC 3 V using two size AA (LR6) alkaline | |
| batteries |
| DC 2.4 V using two commercially available |
| |
| AC house current using the supplied AC adaptor |
Maximum outside dimensions | |
| 130 (W) ⋅ 30.5 (H) ⋅ 130 (D) mm |
| (excluding projecting parts and controls) |
Weight | (5 1/8 ⋅ 1 1/4 ⋅ 5 1/8 in.) |
Approx. 238 g (8.3 oz.) excluding batteries | |
Accessories | AC adaptor |
AC adaptor | Stereo headphones (1) |
Rated input: AC 120 V, 60 Hz |
The specifications and external appearance of this unit are subject to change without notice.
D
C