Aiwa XP-SP910 manual Maintenance, Specifications, To clean the lens → N, To clean the discs → O

Models: XP-SP911 XP-SP910

1 8
Download 8 pages 3.86 Kb
Page 6
Image 6
PHONES/

M

PHONES/

LINE OUT

N

O

Use a commercially available connection cord which has a 3.5ø stereo mini lug at one end and two phono plugs at the other end.

Connect the stereo mini-plug to the PHONES/LINE OUT jack of the unit and connect the phono plugs to the analog input terminals of the external unit.

Note

Turn off the power of both units before connection.

DO NOT connect to the PHONO inputs of an amplifier (with a built-in phonoequalizer-amplifier).

Adjust the volume and DSL on this unit.

MAINTENANCE

To clean the lens → N

If the lens becomes dirty, the player will skip or not play. If this occurs, clean the lens in the following manner.

To remove dust or dry particles, first use a camera lens blower/brush a to blow a few times to loosen particles, then gently brush the lens bclean. Finish by blowing the lens again.

To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe gently from the center to the edge. Lens cleaning solution is commercially available.

Note

Take care not to get too much solution on the swab, which could flow into the unit and cause damage.

Pressing too strongly with the swab could scratch or break the lens.

To clean the discs → O

Before playing, wipe the disc from the center outward with a cleaning cloth. After playing, store the disc in its case.

SPECIFICATIONS

Tracking system

3-beam laser

Laser pickup

Semiconductor laser

D/A conversion

4-times oversampling digital filter + 1-bit DAC

Frequency response

20 – 20,000 Hz (47 k ohms)

Output

PHONES/LINE OUT jack (stereo mini-jack)

Maximum output

12 mW + 12 mW (16 ohms at 1 kHz)

Power supply

500 mV (47 k ohms at 1 kHz)

DC 3 V using two size AA (LR6) alkaline batteries

 

DC 2.4 V using commercially available

 

rechargeable batteries

 

AC house current using the supplied AC adaptor

Maximum outside dimensions

 

132 (W) 30 (H) 141 (D) mm (excluding

 

projecting parts and controls)

Weight

(5 1/4 1 3/16 5 5/8 in.)

Approx. 270 g (9.5 oz.) excluding batteries

Accessories

AC adaptor AC-D603 (1)

 

Stereo headphones (1)

AC adaptor AC-D603

Carrying case (XP-SP911 only) (1)

Rated input: AC 120 V, 60 Hz

The specifications and external appearance of this unit are subject to change without notice.

Page 6
Image 6
Aiwa XP-SP910, XP-SP911 manual Maintenance, Specifications, To clean the lens → N, To clean the discs → O, Phones Line Out