OPERATION
OPERATION
3.3 Tractor 3-Point Hitch
The tractor
The 800 attaches to a tractor with a CAT I or II hitch. Refer to the tractor operator’s manual for the category of the tractor used. If the hitch does not conform to the ASABE CAT I or II dimensions, the blade may not fit or raise properly. Consult an authorized dealer for possible modification procedures to mount nonconforming hitches.
Use the correct hitch pins for the hitch category being used. For a Cat I hitch, 7/8” lower hitch pins are used, and 3/4” top hitch pins are used. For a CAT II hitch,
CAT I Implement / Hitch Specification |
| CAT II Implement / Hitch Specification |
|
Width from outside to outside | 26 7/8” | Width from outside to outside | |
Quick Hitch width inside lug to lug | 27 1/8” | Quick Hitch width inside lug to lug | |
Height from bottom hitch pin to top pin | 18” | Height from bottom hitch pin to top pin | 19” |
Lower pin diameter | 7/8” | Lower pin diameter | |
Upper pin diameter | 3/4” | Upper pin diameter | 1” |
Linch pin diameter | 15/32” | Linch pin diameter | 15/32” |
3.4 Front End Weight
A minimum of 20% total tractor weight must be maintained on the tractor front end at all times. Front end weight is critical to maintain steering control and to prevent the tractor from rearing up while driving. If the front end is too light, add weight until a minimum of 20% total weight is reached on the front tires. Front weights and weight carriers can be purchased through an authorized tractor dealership.
4. GETTING ON AND OFF THE TRACTOR
Before getting onto the tractor, the operator must read and completely understand the implement and tractor operator manuals. If any part of either manual is not completely understood, consult an authorized dealer for a complete explanation.
Do not mount or dismount the Tractor while the tractor is moving. Mount the Tractor only when the Tractor and all moving parts are completelystopped.
800 01/11 | Operation Section |
© 2011 Alamo Group Inc.
