Alamo Exten-A-Kut II manual Driveline Attachment, Setting Boom Mower Height

OPERATION

7.1 Setting Boom Mower Height

1.Park the tractor and boom mower on level ground.

2.Shut down the tractor and remove the key.

3.Level the boom mower from front to rear by extending or retracting the 3-point top link.

4.Level the mower side to side by manipulating one lower lift arm length. On most tractors, at least one of the lift arms is designed to allow for manipulation of its length. Shortening or extending will allow for deck leveling from side to side.

5.Securely block up the mower at this height.

NOTE: Install optional check chains when there is

aproblem with the hydraulic 3-Point lift maintaining a set height or when a constant pre-adjusted cut height is required.

8.DRIVELINE ATTACHMENT

The driveline yoke and tractor PTO shaft must be dirt free and greased for attachment.

To connect the mower driveline to the tractor PTO output shaft, pull the driveline yoke collar back and align the grooves and splines of the yoke with those of the PTO shaft. Push the driveline yoke onto the PTO shaft, release the locking collar, and position the yoke until the locking collar balls are seated onto the PTO shaft. Push and pull the driveline back and forth several times to ensure a secure attachment. OPS-R-0003_A

EK II 03/09 Operation Section 3-11

©2009 Alamo Group Inc.

OPERATION