In keeping with our environmental preservation and compliance commitment, we include
www.atlinks.com
Ecologic
attitude
10.T
In idle/predialing mode: Press to make a call
In Redial list/Call List/Phonebook entry: Press to make a call to the selected entry in the list
During ringing: Press to answer a call
1.2. Handset Overview (Versatis F250 only)
1. M |
In idle mode: Press to access the main menu |
In |
During a call: Press to access Intercom/Phonebook/Redial |
List/Call List |
1.3. Base Station Overview | 3. | INSTALLING YOUR PHONE | |
|
| 3.1. Installing and Charging the Batteries | |
|
| 111 | Slide down to open the battery compartment cover. |
|
| 222 | Place the 2 supplied AAA rechargeable batteries as indicated. |
|
|
| Pay extra attention to direction of polarity. |
|
| 333 | Slide the battery compartment cover back. |
|
| 444 | Put the handset on the base and charge for 15 hours before |
|
|
| using the handset for the first time. The handset will give a |
|
|
| beep when it is properly placed on the base or charger. |
|
| Notes: | |
|
| 111 | Use only the supplied NiMH rechargeable batteries. |
|
| 222 | If the handset will not be used for a long time, disconnect and |
|
|
| remove the batteries to prevent possible leakage. |
1. | A |
|
|
| Press A on the base station to page your handset. It will |
|
|
| ring for approximately 60 seconds. |
|
|
| Press and hold A on the base station for about five seconds, |
|
|
| the base station is entered into registration mode and allows |
|
|
2. | handset registration. |
|
|
, @ |
|
| |
| Steadily on while the handset is charging or in use. (Applicable |
|
|
| only when the LED I/O switch is slid to “I”) |
|
|
| Flash when receiving an incoming call. (Applicable only when |
|
|
| the LED I/O switch is slid to “I”) |
|
|
3. LED I/O SWITCH (Bottom of the Base) | 3.2. Connecting the Base Station | ||
| Slide the switch to "O" position to turn off the base LED | ||
| Slide the switch to "I" position to turn on the base LED when | 111 | Plug one end of the telephone line cord into the telephone |
| the handset is charging on the base or in use |
| jack on base bottom. |
|
| 222 | Plug the small end of power adapter into a power jack on |
|
|
| base bottom. |
|
| 333 | Connect the power supply plug to the base jack |
|
|
| horizontally, and route the power supply cord through |
|
|
| the slot. |
|
| 444 | Plug the large end of power adapter into a wall power outlet. |
1.GETTING TO KNOW YOUR PHONE
1.1. Handset Overview (Versatis F200 Only)
1.M
In idle mode: Press to access the main menu
In
During a call: Press to access Intercom/Phonebook/Redial List/Call List
2.C
In main menu mode: Press to go back to idle screen
In
In
In editing/predialing mode: Press to clear a character/digit
In editing/predialing mode: Press and hold to delete all the characters/digits
During a call: Press to mute/unmute the microphone
In idle mode: Press to intercom another handset
In ringing: Press to suppress handset ringer
3.+
In idle mode: Press to access the call list
In menu mode: Press to scroll up the menu items
In Phonebook list/Redial list/Call List: Press to scroll up the list
During a call: Press to increase the volume
In ringing: Press to increase the ringer volume
4.-
In idle mode: Press to access the redial list
In menu mode: Press to scroll down the menu items
In Phonebook list/Redial list/Call list: Press to scroll down the list
During a call: Press to decrease the volume
In ringing: Press to decrease the ringer volume
5.O
During a call: Press to end a call and go back to idle screen
In menu/editing mode: Press to go back to previous menu
In menu/editing mode: Press and hold to go back to idle screen
In idle mode: Press and hold to power off the handset
In idle mode: Press and hold to power on/off the handset
6.R
In idle/predialing mode: Press to insert a flash
During a call: Press to dial a flash
7.P
In idle mode: Press to access the phonebook list
8.E
In idle mode: Press to access the redial list
9.ALPHANUMERIC KEYPAD, *, #
*key in idle mode: Press and hold to enable or disable the keypad lock
# key in idle mode: Press and hold to turn on/off the ringer
# key in call list mode: Press to review caller’s number if applicable
0 key in predialing/number editing mode: Press and hold to insert a pause
1, 2, 3 key in idle/off hook mode, press and hold to dial the stored direct memory number
2. | C |
| In main menu mode: Press to go back to idle screen |
| In |
| In |
| In editing/predialing mode: Press to clear a character/digit |
| In editing/predialing mode: Press and hold to delete all the |
| characters/digits |
| During a call: Press to mute/unmute the microphone |
| In idle mode: Press to intercom another handset |
3. | In ringing: Press to suppress handset ringer |
+ | |
| In idle mode: Press to access the call list |
| In menu mode: Press to scroll up the menu items |
| In Phonebook list/Redial list/Call List: Press to scroll up the |
| list |
| During a call: Press to increase the volume |
4. | In ringing: Press to increase the ringer volume |
- | |
| In idle mode: Press to access the redial list |
| In menu mode: Press to scroll down the menu items |
| In Phonebook list/Redial list/Call List: Press to scroll down the |
| list |
| During a call: Press to decrease the volume |
5. | In ringing: Press to decrease the ringer volume |
O | |
| During a call: Press to end a call and go back to idle screen |
| In menu/editing mode: Press to go back to previous menu |
| In menu/editing mode: Press and hold to go back to idle |
| screen |
| In idle mode: Press and hold to power off the handset |
6. | In idle mode: Press and hold to power on/off the handset |
R | |
| In idle/predialing mode: Press to insert a flash |
7. | During a call: Press to dial a flash |
P | |
| In idle mode: Press to access the phonebook list |
8. | S |
| During a call: Press to turn on/off the speakerphone |
| In Idle mode/Predialing mode/Redial list/Call List/Phonebook |
| entry: Press to make a call with speakerphone |
| During ringing: Press to answer a call with speakerphone |
9. ALPHANUMERIC KEYPAD, *, # | |
| * key in idle mode: Press and hold to enable or disable the |
| keypad lock |
| # key in idle mode: Press and hold to turn on/off the ringer |
| # key in call list mode: Press to review caller’s number if |
| applicable |
| 0 key in predialing/number editing mode: Press and hold to |
| insert a pause |
| 1, 2, 3 key in idle/off hook mode, press and hold to dial the |
stored direct memory number
10.T
In idle/predialing mode: Press to make a call
In Redial list/Call List/Phonebook entry: Press to make a call to the selected entry in the list
During ringing: Press to answer a call
1.4. Display Icons and Symbols
The LCD display gives you information on the current status of the telephone.
h Steadily on when the handset is in range of the base. Flash when out of range of the base or not registered to the base.
| Steadily on when an intercom is in progress. |
j Flash when there is an incoming internal call. | |
k | Indicate a call is in progress. |
l | (Versatis F250 only) |
Indicate that handsfree is being used. | |
x Steadily on when an alarm is set.
Flash when the alarm time set before reaches. a Indicate that the keypad is locked.
g Indicate when there are received new Voice Message Waiting (VMWI) not yet read.
Disappear when all the voice messages have been read. (Network service dependent)
n Indicate that the ringer is switched off.
b Indicate when the battery is fully charged.
Whole icon flashes when the battery performs initial charging.
Internal block icon flashes when the battery is in final charging stage.
v Indicate when the battery needs charging. Flash when low battery power level is detected.
[
]
s Indicate when new call is received. Turn off when new call has been read.
f ScrollCall List.up/down the menu items/Phonebook list/Redial list/
2.PRECAUTIONS
The signal quality will depend on the location and environment of the base and handset.
Position your Versatis F200/Versatis F250 away from sources of excessive heat (radiators, direct sunlight, etc.) and protect it from vibrations and dust. Never allow your telephone to come into contact with water or other liquids, or with aerosols. To reduce the risk of interference and optimize reception, take particular care not to install the base in the immediate vicinity of windows, large metal objects, reinforced concrete, televisions, music centres, VCR or DVD players, halogen lamps or heating devices, fluorescent lighting, burglar alarms, microwave ovens, computers, etc.
This telephone requires an electrical power supply in order to function.
To clean your Versatis F200/Versatis F250, use an antistatic cloth lightly moistened with water.
NB: Your Versatis F200/Versatis F250 is a DECT™* standard
appliance designed to receive and transmit telephone calls. It is designed for connection to the public telecommunications network.
555Plug the other end of the telephone line cord in to the telephone jack or
666 Always use the cables provided in the box.
If you have broadband service,
a
3.3.Connecting the Charger(s) (for Duo/Trio models) Plug the power adapter into mains socket.
If you have a Broadband line
If you connect your telephone to a line with a broadband connection, you will need to insert a
In a home with broadband, every telephone must have a micro- filter connected, not just the one at the telephone point that your modem is connected to. If you need more broadband micro- filters, contact your broadband supplier.
www.atlinks.com
ATLINKS Europe
22 quai Gallieni
92150 Suresnes- France
© ATLINKS 2011 - Reproduction prohibited.
The Manufacturer reserves the right to modify the specifications of its products in order to make technical improvements or comply with new regulations.
ALCATEL and ATLINKS are registered trademarks.
The Alcatel logo and Alcatel name are trademarks of Alcatel and used under licence by ATLINKS.
F200/F200 Duo/Trio
F250/F250 Duo/Trio
A/W No.: 10000259 Rev.1 (EN)
Printed in China
