![](/images/new-backgrounds/1108357/10835713x1.webp)
Installing the Hardware
Items Required
In addition to the materials and components provided in the OmniSwitch 6850 Series shipment, you must provide the following items in order to complete this installation:
•Grounding wrist strap
•Phillips screwdriver
•Serial cable
•Rack mount screws, if applicable
Site Preparation
Environmental Requirements
OmniSwitch 6850 Series switches have the following environ- mental and airflow requirements:
•The installation site must maintain a temperature between 0° and 45° Celsius (32° and 113° Fahrenheit) and not exceed 95 percent maximum humidity (non- condensing) at any time.
•Be sure to allow adequate room for proper air ventilation and access at the front, back, and sides of the switch. No clearance is necessary at the top or bottom of the chassis. Refer to page 6 for minimum clearance requirements.
Electrical Requirements
OmniSwitch 6850 Series switches have the following general electrical requirements:
•Each switch requires one grounded AC power source.
•Grounded AC power source must be 110V for North American installations (220V international).
•Each supplied AC power cord is approximately 2 meters (6.5 feet) long. Do not use extension cords.
NEBS GR-1089 Compliance Requirements
The following notes and warnings apply to all NEBS compliant platforms.
Grounding requirements: To ground the equipment prop- erly, connect a Panduit Corporation UL listed Lug, P/N:
Use Panduit Corporation, P/N:
June 2007 | Installing the Hardware 3 |