OmniAccess 6000 LC-2G24F Installation Notes: Installation Guide
2Part 031658-00 May 2005
This handle is used for removing or inserting the module into the switch
chassis.
24 FE Ports
These ports are used to connect APs and wired LAN segments to the Alcatel
Wireless LAN Switch. These ports provide 10/100 Mbps Ethernet connectivity,
and in some cases, power and serial connectivity as well. See “Port and Cable
Specifications” for more information.
LNK/ACT LED
Each FE port has its own LNK/ACT LED, located at the left side of the port.
During operation, these LEDs provide the following status information:
Module Indicator LEDs
Power LED
This LED lights green when the line card is properly installed and the system is
powered up.
Status LED
During operation, the Status LED provides the following information:
CAUTION—Do not use the line card handle to lift or move the Alcatel
Wireless LAN Switch. Serious damage could result.
TABLE1 FE LNK/ACT LED
Status Description
Off No Ethernet link on the port.
Green An Ethernet link has been established on the port, but no
data is currently being transmitted or received.
Flashing
Green
The port is transmitting or receiving data. The flashing
rate is proportional to your network activity.
Amber The Ethernet link on the port is encountering errors.
TABLE2 Line Card Status LED
Status Description
Off The line card is powered off or initializing.
Green The line card is operating properly.
Amber The line card is being initialized.
Red The line card has failed.
3
4
A
B