Using the HDD Copy Dock Duplicator

Loading Hard Drives

1.Use the included power adapter and cord to plug the HDD Copy Dock Duplicator into a power outlet.

2.Insert the SATA Hard Drive you want to copy into the slot marked “SOURCE DISK 4”. When inserting, align the SATA port on the Hard Drive with the SATA connector in the drive bay slot. Press the “SOURCE DISK 4” power button on the front of the unit to power up the drive.

3.Insert the destination SATA Hard Drives into the slots marked “TARGET DISK 1”, “TARGET DISK 2” and “TARGET DISK 3”. When inserting, align the SATA port on the Hard Drive with the SATA connector in the drive bay slot. Press the power button on the front of the unit to power up the drive target drive(s).

Note: Make sure the target Hard Drive has the same or higher capacity than your source Hard Drive. The duplication process will not start if the target drive has

a lower capacity. Also make sure the unit is not connected to a PC through the USB or eSATA ports.

4.Push the main power button to turn the unit on.

5.Push the DOWN button to select the Duplicator Mode menu item and press ENT. Press ENT two more times to switch to Duplicator Mode.

The system will auto-detect the hard drives. After the drives have been detected, a screen similar to the one below will be displayed:

==HDDDuplicator.Menu ==

UP

ENT

1.-1Copy HDD ver:

 

POWER

DOWN

ESC

 

Note: Before copying be sure that the capacity of the target HDD is equal to or larger than the source hard drive.

6

www.aleratec.com