Using the HDD Copy Dock Duplicator

Duplicator Mode

Main Menu: Copy HDD

The “Copy HDD” function performs an actual copy from the source HDD to the target HDD. The target HDD must be at least as large as the source. The HDD Copy Dock Duplicator will copy every block of capacity on the source HDD.

1.Load the source HDD and the target HDD(s) into the HDD Copy Dock Duplicator. The system will auto-detect the hard drives. After the drives have been detected, a screen similar to the one below will be displayed:

==HDDDuplicator.Menu ==

UP

ENT

1.-1Copy HDD ver:

 

POWER

DOWN

ESC

 

Note: Before copying be sure that the capacity of the target HDD is equal to or larger than the source hard drive.

2.Press ENT to start copying. The system will auto-detect the hard drives.

3.During the copy process the HDD Copy Dock Duplicator will display progress information.

CopyHDD Duplicator- 36MB/s

0%

2351-1.7GB

ver: 00:01:48

 

 

 

UPENT

POWER

DOWNESC

The amount of data remaining to be transferred (shown in gigabytes), and time will be displayed in increasing increments as the percentage of completion increases. The process information is refreshed every 15 to 20 seconds.

Note: The copying speed, capacity and duration may vary from one source hard drive to another.

4.Once duplication is complete, a job status screen will be displayed:

FinalHDD Duplicator38 MB/s

100%

01.-01GB

ver:00:32:57

 

 

 

UPENT

POWER

DOWNESC

www.aleratec.com

7