AllerAir Industries Inc.
AirTube Series
Congratulations, you are moments away from fresher, cleaner indoor air. Your new AllerAir unit will combat many of the chemicals, gases, odors and particles responsible for poor indoor air quality, and in turn, health concerns such as allergies, asthma, sick building syndrome and multiple chemical sensitivity. As with any air cleaner, proper maintenance of your unit is a vital part of keeping it operating at peak efficiency.
Operation:
Your unit is shipped fully assembled and ready for use. Plug into 120V- 15amp outlet. For best results situate your unit close to your sitting, sleeping or work area.
REPLACING FILTER ASSEMBLY-
AirTube & Air Tube Supreme
NOTE: Please save your packaging. Original packaging will be required for all warranty returns.
WARNING !
Before removing the top or bottom of the unit for any reason, always unplug the cord from the power supply.
Step 1
Turn Power Off and unplug receptacle.
Step 2
Gently lay unit
Step 3
Remove lid by pulling slightly on cover.
A
B
Maintenance:
AirTube & Air Tube SupremeThe HEPA Filter (Model AirTube HEPA)
Should be changed after approximately 24 months of use in an average home environment. A noticeable lessoning of airflow is a sign that it may be time to replace this filter.
The Carbon Filter (Model AirTube Carbon)
Should be changed after approximately 12 months of use in an average home environment. A noticeable decrease in air quality could also be a sign that it may be time to replace this filter.
The
Replace or vacuum from the outside of the unit every
AirTube Jr.
The Electrostatic HEPA Filter(Model AirTube Jr. Electrostatic HEPA)
Should be changed after approximately 12 months of use in an average home environment.
A noticeable lessoning of airflow is a sign that it may be time to replace this filter.
The Carbon Filter (Model AirTube Jr. Carbon)
Should be changed after approximately
Step 4
First remove HEPA filter by placing your hand on the inner side of the filter.
Then pull up gently until totally out.
Step 7
Replace all filters with new ones then reassemble by inserting the Carbon filter first then the HEPA.
Step 5
Now remove Carbon filter by placing hands on the inner side of the filter.
Then pull up gently until totally out.
Step 8
Place lid back to its proper position by aligning screw holes.
Step 6
A- To replace
B- To replace
Step 9
With a screw driver, place 4 screws back into their positions.