| Section 5: Maintenance | 11 |
|
|
|
|
|
|
WARNING
Before inspecting, cleaning or servicing the machine, shut off engine, wait for moving parts to stop, dis- connect spark plug wire and move wire away from spark plug.
Failure to follow these instructions can result in serious personal injury or property damage.
ENGINE MAINTENANCE
WARNING
The temperature of the muffler and adja- cent engine areas may exceed 150oF (65oC). Contact may cause burns. Avoid these areas. Remove the spark plug lead and ground the lead to the engine to prevent accidental starts and fires.
Failure to do this could cause personal injury.
•Maintain the correct engine oil level and change the oil as recommended (more often in dusty conditions).
•Keep the air filter clean. Operating the engine with a dirty, clogged air filter can cause poor performance and damage to the engine. Never operate engine without air filter installed.
•Keep the spark plug clean and properly gapped. Replace every 2 years.
•The engine cooling fins must be kept clean to prevent overheating of the engine.
WARNING
Do not tamper with the engine governor screw which is
• If the engine is equipped with a spark |
arrester, clean it every year. |
• Clean, check or adjust the following |
items according to the instructions in the |
narrow,
WARNING
Avoid contact with the cutting edges on the tines.
To avoid personal injury when removing or installing tines, wear heavy work gloves. The engine must be off, all moving parts stopped, and the spark plug wire disconnected from the spark plug and moved away from the plug.
Arranging Tines for Narrow Tilling
1.Prop the machine forward so it rests on the front of the tubular carrying handle. The work surface should be flat and firm.
2.Flip open the ring (A, Figure 12) on the left side ring lock pin and remove the ring lock pin.
IMPORTANT: The ring lock pin (A, Figure
12)is under spring tension – use care when removing or replacing the ring lock pin.
A |
Figure 12: Standard wide tine pattern and ring lock pin location.
5.Repeat this procedure on the opposite
side. |
B |
Figure 13: Narrow tilling pattern.
Arranging Tines for Stony Soil
1.Prop the machine forward so it rests on the front of the tubular carrying handle. The work surface should be flat and firm.
2.Remove the ring lock pin (A, Figure 12) from both sides of the unit. Remove both outer tine sections. Be sure to mark each section as a left or right side tine and whether it is an inner or outer section.
3.Remove the inner tine sections and
swap their positions (the inner
4.Reinstall the two outer tine sections onto the sides from which they were removed (Figure 14).
5.Insert the ring lock pins through the rounded side of the tine shafts and snap the rings down over the shafts (see DETAIL - Ring Lock Pin, Figure 10, in Sec- tion 4).
Engine Owner’s Manual: fuel tank, fuel |
filter, clutch shoes, idle speed, valve |
clearance and fuel tubes. |
3. Remove the outer tine section (do not |
|
remove inner tine section) and mark which |
|
side it is from (left or right), and whether it |
|
is an outer or an inner tine section. | Figure 14: Stony soil tine pattern. |
TINE REMOVAL
AND INSTALLATION
The tines wear with use and should be replaced if tilling takes longer than usual or if the soil does not mix thoroughly. In addition to the standard 10" tilling width tine pattern, the tines can be arranged in a
4.Slide one of the long bushings (B, Figure 13), provided with the unit, onto the shaft. Insert the ring lock pin through the rounded side of the tine shaft and snap the ring down over the shaft (see DETAIL - Ring Lock Pin, Figure 10, in Section 4).
