To Clean the Dispenser
Remove the dispenser housing from agitator by squeezing the lower part of the dispenser, pulling directly upward and at the same time tilting slightly. This will expose the dispenser cup, which is also removable, for cleaning (refer to illustration). Both housing and cup can be soaked in hot soapy water and rinsed clean. The funnel shape in top of agitator also needs to be cleaned. The hole and the slots in the two rings will require using a small brush for proper cleaning.
After cleaning, install dispenser cup, then push dispenser housing directly downward onto top of agitator until firmly snapped together.
Dispenser Housing
Dispenser Cup
Agitator
TLW2001N
TLW2001N
Use Tips
•Fabric softener spilled onto garments may cause staining. To remove, dampen stain and rub with bar soap. Wash as usual.
•Liquid fabric softeners will be dispensed during the final rinse and should not be combined with bleach, bluing, starch, detergents, soaps or packaged water conditioners.
•Fabric softener is not to be used in dispenser when using Prewash cycle, if available.
•When adding detergent to wash water, do not allow any to enter into softener dispenser cup, as softener will become gummy.
To prevent softener buildup, the dispenser can be filled with clean water for automatic cleaning. This can be done in washing cycles other than when softener is used.
Agitator Cap
IMPORTANT: If your washer comes with an agitator cap, the cap must be on at all times.
201959
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
