Viking F20507 Replacing Oven Lights, To start the Self-Clean cycle, To stop the Self-Clean cycle

Self-Clean Cycle

To start the Self-Clean cycle:

1.Close the door completely.

2.Turn the oven selector knob clockwise to the “SELF CLEAN”mode.

3.Turn the temperature control knob past the clean settingntilu the knob stops. At this time, the clean indicatorlight will come on. Within 30 seconds the automatic dor latch engages and the oven indicator light comes on. The oven indicator light will remain on until the oven reaches the self-clean temperature and will then cycle on and off during the self- clean cycle. When the oven reaches the elevated temperature needed for self-clean, the door lock indicator light comes on.

4.The door lock indicator light will remain on untilthe self-cleanis completed or interrupted andthe oven temperature drops to a safe temperature. A complete cycle isapproximately 3-1/2 hours with an additional 30 minutes neededfor the oven to cool down enough for the door latch to disengage.

Note: A fan noise will be heard during theself-cleancycle and will continue to run for the 3-1/2 hour duration of the self-clean cycle.

5.When thecycle is completed, turn both the oven selector and temperature control knob tothe “OFF”position. When the oven has completely cooled, open door and remove any ash from the oven surfaces with a damp cloth.

To stop the Self-Clean cycle:

To cancel or interruptthe self-cleaning cycle, turn both the temperature control knob and the oven function selector knob to “OFF”. When the oven temperature drops to a safe temperature,the automatic door latch will release and the oven door can be opened. When the ovenhas completely cooled, remove any ash from the oven surfaces witha damp sponge or cloth.

Product Care

Replacing Oven Lights

WARNING

ELECTRICAL SHOCK HAZARD Disconnect the electric power at the main fuse or circuit breaker before replacing bulb.

CAUTION

To avoid risk of personal injury, DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth.

	glass light
1. Unsnap glass light cover	cover
using a screwdriver in the
access groove.
	access
	groove
2. Firmly grasp light bulb and
pull out.
	light
	bulb

3. Replace with halogen bulb using volt and wattage requirements listed on glass cover.

4. Replace the light cover by snapping glass cover onto metal box.

5.Reconnect power at the main fuse or circuit breaker.

Product Care

42 43