Alliance Laundry Systems 70269501R3 Electronic OPL Control, OM Control Suffix, Figure, Programming Manual, 2. Press START pad to start tumbler

Operating Instructions

ON / SELECT		STATUS	PROGRAM
HIGH	START	DRYING	AUTO	TIME
	START	DRYING
			AUTO
MEDIUM	STOP/RESET	COOL DOWN	SPECIAL	SPECIAL
MEDIUM	STOP/RESET	COOL DOWN	CYCLE	TIME
MED LOW	TEMP	DOOR OPEN	*TEMPAUTO	COOL
	DISPLAY			*DOWN
	F/ C
LOW	SIGNAL	CUSTOM	MORE	LESS
			+	--
NO HEAT			CONDITION	SAVE
				CUSTOM
				PROG

TMB1789N

Figure 6

Electronic OPL Control

OM Control Suffix

1.To use an Automatic Cycle, press an ON/ SELECT pad. Select HIGH, MEDIUM, MED LOW, LOW or NO HEAT for items that should not be dried with heat. A light to the left of the selected pad lights up.

To use a Time Dry or Custom Cycle, refer to the Programming Manual.

NOTE: Do not press directly on lights or the center of pad. For proper selection, press on pad slightly to the right of center. Refer to Figure 7.

2. Press START pad to start tumbler.

NOTE: All pads can be pressed in any sequence without damaging control or tumbler. To stop the tumbler at any time, open the door or press STOP/ RESET. The window display will flash. Press STOP/RESET twice (within 3 seconds) to end the cycle and reset the control to idle status. To restart the tumbler, CLOSE door and press START pad.

IMPORTANT: If the loading door or lint panel door is opened during the cycle, the heating system will shut off and the motor will stop. To restart the cycle, both doors must be closed and the PUSH TO START button must be pressed in.

3.When the cycle is complete, open door and remove the laundry.

TMB806N

Figure 7

70269501