Alliance Laundry Systems CHM160C Display Indicators

Operation

Display Indicators

Table 1 lists the various displays and what they mean. The operator should become familiar with these machine displays.

	Display	Meaning

	tESt	Diagnostic test cycle selected or enabled

	SPIn	Spin (extract) step

	SUP1	Supply signal 1 (“S1” output), normally detergent

	SUP2	Supply signal 2 (“S2” output), normally bleach

	SUP3	Supply signal 3 (“S3” output), normally softener

	SdLY	Spin coast (motor coasts after high speed extract)

	CFIL	Cold Fill

	HFIL	Hot Fill

	bFIL	Warm Fill (cold + hot)

	bLCH	Control will also light “add bleach” indicator

	PASS	Variable-speed ONLY – balance “PASS” condition; shows in “test” cycle only

	FAIL	Variable-speed ONLY – balance “FAIL” condition; shows in “test” cycle only

	bAL?	Variable-speed ONLY – meaning: “Do you wish to enter balance detection test routine?”

	CY__	Cycle number (followed by a space and number 1 through highest cycle number)

	norn	Normal agitation selected

	gEnt	Gentle (reduced) agitation selected

	For	Wash speed forward (during test cycle)

	rEv	Wash speed reverse (during test cycle)

	dISt	Variable-speed ONLY – distribution speed (during test cycle)

	LO	Low water level

	nEd	Medium water level

	HI	High water level; also denotes “HIGH” spin speed in variable speed “test” cycle.

	CEL	Display all temperatures in degrees Celsius

	FAr	Display all temperatures in degrees Fahrenheit

	___C	The first 3 digits are reserved for temperature reading, C indicates “degrees Celsius”

	___F	The first 3 digits are reserved for temperature reading, F indicates “degrees Fahrenheit”

	FILL	“Fill error” – machine did not fill to programmed water level within 10 minutes; also shows
	FILL	during Rapid Advance mode, refer to Programming Manual
		during Rapid Advance mode, refer to Programming Manual

	door	“Door” opened during cycle

	SHUt/door	Machine user must “shut door” of the washer to allow the cycle to begin

		Table 1 (Continued)

F232172