Operation
| Table 1(Continued) | |
|
| |
Display | Meaning | |
|
| |
CAnt/OPEn | Control cannot unlock the door | |
|
| |
COIn | Control will interpret both coin inputs as signals from a drop coin meter meaning coins must | |
fall through slot at a certain rate to be counted as valid coins. | ||
| ||
|
| |
Con1/dEnO | Denomination assigned for coin 1 input (example: .25 would mean a US quarter) | |
|
| |
Con2/dEnO | Denomination assigned for coin 2 input (example: 100 would mean a US dollar) | |
|
| |
CArd | Control will interpret the coin 2 input as a START signal from a card reader with no timing | |
max restriction, meaning the signal can last any amount of time once recognized. | ||
| ||
|
| |
USH1 | “Wash 1” segment | |
|
| |
USH2 | “Wash 2” segment | |
|
| |
USH3 | “Wash 3” segment | |
|
| |
USH4 | “Wash 4” segment | |
|
| |
rIn1 | “Rinse 1” segment | |
|
| |
rIn2 | “Rinse 2” segment | |
|
| |
rIn3 | “Rinse 3” segment | |
|
| |
rIn4 | “Rinse 4” segment (final rinse) | |
|
| |
donE | Cycle has concluded | |
|
| |
drAI | Drain selected for segment; also indicates in drain step during 2 speed version test cycle and | |
in Rapid Advance. Refer to Programming Manual. | ||
| ||
|
| |
Flashes for a period of time (for safety) after power up while keeping outputs OFF | ||
|
| |
nodr | No drain selected for segment. Machine does not drain for segment. | |
|
| |
SUP6/S 12 | Supply 1 and 2 together | |
|
| |
EFIL | Machine set up for extra fill valve. Valve MUST be installed on machine. “EFIL” displays | |
when programmed for extra fill step. | ||
| ||
|
| |
nEFL | Machine not equipped with extra fill valve | |
|
| |
HEAt | Machine heat functions enabled in control. Machine MUST be equipped with electric or | |
steam heat capabilities. | ||
| ||
|
| |
noHt | Machine heat functions NOT enabled in control. “noHt” MUST be selected in set up mode if | |
machine does not have electric or steam heat capabilities. | ||
| ||
|
| |
bEEP | Beep enabled during supply 2 (bleach) and at end of cycle | |
|
| |
nobP | Beep disabled during supply 2 (bleach) and at end of cycle | |
|
| |
Setup/configuration code = xx (xx means setup code) | ||
|
| |
Factory cycle ID program code = yy (yy means setup code) | ||
|
| |
Adv | Rapid Advance, refer to Programming Manual. | |
|
| |
Erdn | Drain count error (depending on model) | |
|
| |
| Table 1(Continued) |
12 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232172 |