Alliance Laundry Systems Clothes Dryer 17

NOTE: When connecting to a gas line, an equipment shut-off valve must be installed within

1.8m (6 feet) of the dryer. An 1/8 in. NPT pipe plug must be installed as shown for checking inlet pressure. Refer to Figure 8.

D233I

1New Stainless Steel Flexible Connector - (Use design CSA certified connector) Use only if allowed by local codes

21/8 in. NPT Pipe Plug

3Equipment Shut Off Valve

4Black Iron Pipe

Shorter than 6.1 m (20 ft.) - 9.5 mm (Use 3/8 in.) pipe

Longer than 6.1 m (20 ft.) - use 12.7 mm (1/2 in.) pipe.

53/8 in. NPT Gas Connection

Figure 8

4.Tighten all connections securely. Turn on gas and check all pipe connections (internal & external) for gas leaks with a non-corrosive leak detection fluid.

NOTE: The dryer and its appliance main gas valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 3.45 kPa (1/2 lb./in.2). Refer to Step 8 (Check Heat Source).

L.P. (Liquefied Petroleum) Gas, 93.1 MJ/m3

(2500 Btu/ft3), service must be supplied at 10 ± 1.5 inch water column pressure.

For proper operation at altitudes above 1070 m

(3500 feet) the L.P. gas valve spud orifice size must be reduced to ensure complete combustion. Refer to Table 3.

						Installation

	L.P. Altitude Adjustments
Altitude			Orifice Size				Part
m	feet	No.		mm	inches		No.
1070	3500	54		1.40	0.0550		503785
2290	7500	55		1.32	0.0520		58755
3355	11000	56		1.18	0.0465		503786

Table 3

NOTE: DO NOT connect the dryer to L.P. Gas Service without converting the gas valve. Install L.P. Gas Conversion Kit 458P3 (available at extra cost).

Step 4: Reverse Door, if Desired

NOTE: Doors with windows cannot be reversed.

The door on this dryer is completely reversible. To reverse door proceed as follows:

1. Remove four hinge attaching screws.

D675I

Figure 9

2. Remove all nine screws.

D272P

Figure 10

512686