Vending
Slide Extension
(Coin Slide Models Only)
1.Remove slide extension parts from parts accessories bag included in unit.
2.If installing a Greenwald coin slide, position extension lever (to be installed on extension bracket) with arm that has one star facing down. Refer to Figure 26.
Greenwald | Monarch or |
Coin Slide | ESD Coin Slide |
One Star | Two Stars |
|
TLW2088N
Figure 26
3.If installing a Monarch or ESD coin slide, position lever with arm that has two stars facing down. Refer to Figure 26.
4.Install extension lever with rounded corner facing away from extension bracket using bolt, one or two flat washers (shims) (use number of washers included in kit) and nut. Refer to Figure 27. Make sure washers are flat against bracket.
Spring | Bolt | One or Two |
Flat Washers (Shims) | ||
|
| Rounded Corner |
Loops |
| Nut |
|
|
Extension Bracket | Extension Lever |
| |
| TLW2089N |
Star(s) Facing Down
TLW2089N
Figure 27
5.Torque nut between 2 and 2.26 Nm (18 and 20
6.Install extension spring in bracket hole and hole in upper arm of lever. Refer to Figure 27.
7.Bend loops closed after installation.
8.Check to make sure the lever swings freely.
Installing Extension Onto Coin Slide:
Option 1
1.Install slide extension onto top of coin slide using two remaining screws and lockwashers. Refer to Figure 28.
Attaching
Screws
Lockwashers
Coin Slide
Slide
Extension
TLW1564K
Figure 28
2.Insert coins and partially extend coin slide.
3.Insert coin slide on its side through meter case opening. Then rotate 90 degrees to its proper orientation.
4.Return coin slide and hook slide pins onto meter case.
5.Continue coin slide installation according to manufacturer’s instructions.
NOTE: During coin slide installation, make sure activation lever is up and off the switch. Refer to Figure 29.
28 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 512686 |